Decarb iso oil?

Discussion in 'Cooking With Cannabis' started by mushroom head, Aug 30, 2013.

    mushroom head

    mushroom head Well-Known Member

    Wanted to make some candies, was going to use iso honey oil, question though should I decarb then make the oil, or make the oil then decarb??

    qwizoking Well-Known Member

    Most people use a double boiler type and heat the iso watching co2 bubbles form and escape. When no more of those bubbles are forming its done. This method is a bit more precise than baking weed in the oven and not really knowing when its finished or if it is....

    BluJayz Well-Known Member

    To minimize loss, mix candies in the same container you double boil it in, go for the precision method mentioned above. It takes about 30min after reaching full temp for the bubbles to stop.

    Edit: use pyrex or metal and it helps to lean it on its side and allow the oil to pool in a corner.

    loopieblunt New Member

    it would be nice if someone actually answered the question of when to decarb
    Hugo Phurst

    Hugo Phurst Well-Known Member

    No difference really.

    IMO it's easier to decarb pot than oil.

    DemonTrich Well-Known Member

    Decarb then cook/bake

    And it's much easier to decarb oil than flowrr
    Thundercat likes this.

    loopieblunt New Member

    I've been using hot oil bath to decarb the oil I make. Using a 6 cup Pyrex measuring cup, it's made for higher temps. It works well. I find the oil gets around the same temp as the bath. So a digital therm. Is def reccmd. I then add mct oil & lecithin, after cools then put into dropper for easy dossage.

Share This Page