Don't mind the droopy plant I fed it right before i snapped the pic
What beautiful looking Christmas trees. Instead of a Star on the top you got some phat bud. Nice!figured I would put up an update, my droopy hempy auto has turned around for the better
View attachment 2438020
Thanks alot Moebius! I'm really loving the hempy style as this is my first time using it. I may have flipped them too early with the space i have but oh well lol. Question: I'm using the maxibloom lucas formula and they are really happy with it, but I was wondering if hempy can be even better with a normal nute regimen? example I have botanicare and canna nutes lying around that I use with my peat mix/perlite runsWhat a beautiful looking Christmas trees. Instead of a Star on the top you got some phat bud. Nice!
Yes, your Hempy can be better with a 'bespoke' nute regime than one proposed by 'Lucas'.
Nice one Steve. Good luck with the other two.
Sounds like a plan bawlout. Youve not included your room size but assuming thats large enough 'what could go wrong'?
Moebius is correct-a-mundo about leaks on the suction side of the fan..I too replaced a section of flex that had pinholes in the mylar coating....shining a flashlight at the outside while looking into the inside told the story. As well, look for leaks inside the room at the push side of the fan if blowing to the outside. I like wrapping flex with duct-tape before tightening the metal clamp. Sometimes carbon can be just plain ineffective during times of high humidity, like right after a rain storm in my area.
Looking good Rusty! I have a bean of this myself, but won't be till next fall that it's popped. Can't wait to see the yields. From the pics of other grows I've seen, it gets extremely frosty! Just in time for Christmas!Hey GUYS,, I'm working my First SCROG.. My Hempy's are 3 Gallons and they seem to be loving the new CMH Bulb setup I installed a couple of weeks ago, based on the Posts here.
View attachment 2438748
Just went with the basic Northern Lights x Big Bud this time around
100% Perlite
GH Flora Series - 700ppm (.5) on week 4
400w CMH Open Fixture
Moebius, so I looked down the aluminum vent and sure enough it looked light Christmas lights on the inside. What's the best duct to use for the grow room? Insulated ducts? Man, if I were to tape this whole vent it would 1.) take me FOREVER, 2.) cost me a bloody fortune in tape! Just wanted to check to see what everyone else has used. I'm using this duct for my air cooled hood and I know that odor must be getting sucked into it.
great start there. They look like they can be pulled under. My rule is if its long enough to cross a link of screen it's long enough to tuck. You might run into some watering issues when the screen fills up and so close to the pot tops. Once there's growth and whatnot going on it might be snug getting in there.Hey GUYS,, I'm working my First SCROG.. My Hempy's are 3 Gallons and they seem to be loving the new CMH Bulb setup I installed a couple of weeks ago, based on the Posts here.
View attachment 2438748
Just went with the basic Northern Lights x Big Bud this time around
100% Perlite
GH Flora Series - 700ppm (.5) on week 4
400w CMH Open Fixture
A few weeks back I compared the Alu Ducting from 2 different local hydroponic stores. One came in a box and was branded and had clips the other came without box was unbranded and looked cut-to-size. The boxed/ branded Alu Ducting was a much higher quality with far fewer holes. .... I moved the holey ducting onto the 'expel' side of the fan.