DIY with Quantum Boards

ianc4990

Well-Known Member
What are you using to make those frames? Definitely digging your layout and those frames make for a practical setup.
The veg light is made from 3 foot angle aluminum. I think its half inch or 3/4 angle from lowes. I didnt even cut them down. Just drilled hole in the overlap corners and bolted the frame together with the qb120 with some machine screws. Less than 20 dollars all together per 4x4 of frame and bolts. MAKE SURE TO NOT HIT THE OPEN SOLDER POINTS ON THE QB120 BOARDS!
 

pop22

Well-Known Member
I didn't think they looked like a legit dealer either. If whoever you bought from isn't replying................ time to raise some hell!


Which light did you order? Not one of the discontinued Diablo kits right?

If you ordered from the site you linked, ShopGrowSpaces, maybe the issue is on their end. Have you contacted them?
 

WeedSexWeightsShakes

Well-Known Member
Hey guys quick driver pairing question.
I have some QB132s and was wondering if I could use a hlg 240 c1050 driver wired in series?
current drivers I have them on aren’t dimmable. wife wants to use them but doesn’t need them blasting.
thanks
 

TWest65

Well-Known Member
Hey guys quick driver pairing question.
I have some QB132s and was wondering if I could use a hlg 240 c1050 driver wired in series?
current drivers I have them on aren’t dimmable. wife wants to use them but doesn’t need them blasting.
thanks
At 1050 ma, the qb132 boards should be around 33 volts each, times 4 is 132v. The hlg240-c1050's constant current range is 119 to 238 volts. So you're good to go.
 
Top