I have a a good 8-9 grams of kif but it has quite a bit of plant matter in with it. I read somewhere that the trichs are heavier than water and the plant matter isn't so in theory to purify my kief could I just throw it in some cold water, shake it up real good, and then let it settle out?
In...
Would using a high concentration of ozone over a 2-3 hours in your grow room be enough to kill off spider mites?
And if so is it possible to hit them with enough ozone to kill them but not harm my plants? Something like a 15 minute ozone treatment a day or something to that effect?
I've got...
Ok so here's the deal. I want to run a 1000w and 600w HPS light in an enclosure where the ceiling is only 43" from the floor. This area will be cooled with an elicent 8" inline fan thats 636 cfm I believe and both light will be in air cooled hoods. The plants will be in 24"x16"x9" rubbermaid...
Hi I was wondering if using 2ft fluorescent tubes to veg my 1 plant scrog would be a good idea? The enclosure is 30x20x36 and I'm using a 250w HPS for flower.
Will it take a substantial amount of time longer to veg using 2 cool white bulbs instead of a 250 MH? I am mainly concerned about...
Much oblige! I've never hit the .5 g/w ratio before and have only grown with a 600w but I think that was due to my style and low plant count. Never used the screen before but if it works anything like the pictures it should do wonders for my yield.
Thanks again
Hey everyone just have a quick 2 questions for you all. I'm looking to get 3/4 of a lb harvest every 3 months with a 1000w light in a 4x4 tent. I have a 3x3 scrog screen I made and think just filling that up with a decent yielding strain should do the trick but I would like to get an opinion...
It's an Advance ballast and yes it's grounded. Overheating sounds possible since after about 5 mins I can turn it back on but I just don't see it overheating that quickly. I'll check the grounds again.
Any chance it could be the bulb? It's new but I had it hooked up to a 250w lumatek...
Hi. I just bought a new 250w MH ballast, wired it up and it works fine except that after about a minute the bulb just shuts off even though the ballast is hummin' away. Anyone know what the problem could be?