everybody has there own way of cloning, and im a believer of using whatever method works best for you. here is my way of cloning, i get 100% success most batches
the Tools of the Trade
my cabin has limited space, so i setup on my dining table
(notice the tag on the board? its called a Budda Board and you paint on it with water, which dries up in a few minutes)
the Mom, a Gigabud from G13.
i cut from any part of the plant, depending on whether it needs to be shorter or get trimmed from the bottom up.
then into a glass of water until i cut half a dozen or so
(check out the budda board now)
prep the Scalpel, they say that they have been sterilized with gamma radiation
then i pull a clone out of the glass and put it in the pie dish, cutting off the lowest set of nodes then cutting the mainstem just below them, all cuts done underwater.
poke a lil hole in the rockwool, the pre-made holes are too big
then a dip in the cloning gel, and firmly set in the rockwool atleast 1cm deep.
trim off half the big fanleaves so it dosent droop, and into the cloning dome, which has a heating mat under it and a little flouro above it.
thats my cloning setup, feel free to post up your own ways, or add any helpful insight
hope everbody is having a good new year!
-Lank
, i ate them yesterday.
