Introducing CobKits.com - specializing in DIY and Citizen COBs

ANC

ANC

Well-Known Member
I like it, except for the wagos. A bit of solder and some heat shrink makes for a neater job
Maybe get some ribbed conduit from the auto parts place to bundle up the other wires..
 
1

1212ham

Well-Known Member
ANC said:
I like it, except for the wagos. A bit of solder and some heat shrink makes for a neater job
Maybe get some ribbed conduit from the auto parts place to bundle up the other wires..
Click to expand...
Don't forget good old wire nuts. Not high tech, but cheap and very effective, proven millions of times in millions of homes for decades. Quite effective for connecting several wire or a large number wires in parallel, with all wires connected at one point it guaranties they are all at the same potential (voltage). I use Wagos, wire nuts or solder depending on the situation.

"600+ watts of fuck your retinas" I hope the dog is ok. lol
My cat would look right at a cob when I was testing stuff on the floor! She liked the heat.
 
Last edited:
Go go n chill

Go go n chill

Well-Known Member
DesertHydro said:
I just capped them with wagos for now. gonna throw a cool toggle switch on this bitch so I have an on and off. anyone know if I need some sort of relay or just connect a switch?
this hlg600 has a nifty blue LED on it that the others don't. I feel special. driver gets mounted tomorrow and then I will clean up the wiring and get it hung. 600+ watts of fuck your retinas
View attachment 4060270 View attachment 4060271 View attachment 4060272
Click to expand...
Have you mounted your driver or is it going to be remote? I mounted mine using some stand-offs.... It was my solution...
image.jpg
 
DesertHydro

DesertHydro

Well-Known Member
I got some one inch aluminum flat bar and made some braces going across the center and then riveted it into that. Looks clean to me and that's all that matters. Wanted to make sure the weight was centered so it doesn't lean. I wanted to do standoffs but couldn't find them locally
 
pop22

pop22

Well-Known Member
I use one in this cab for all kinds of little grow project. I've even flowered 2 plants under it. Great for seedlings and clones!

Go go n chill said:
I made a comment somewhere about how much of a good investment a single engine is... For a first time grower. For the price I think it beats all options.
Click to expand...
 
K

kaivorth

Active Member
IMG_20171120_195744.jpg IMG_20171120_194923.jpg IMG_20171005_230435.jpg

Just wanted to show my last grow. Ran into a few issues:

Light was too close, not enough stretch
Couple nutrient issues
SCROG was setup way too late
Harvested too late

All of the above will be taken care of next grow :)

Moving to Mega Crop Nutes
Moving from soil to Canna Coco
Will use a Hydro Halo on a timed schedule with a res
 
You must log in or register to reply here.
Top