yea wanna hear a funny story....
Get some clear silicon for that crack, should be fine after.
That is what i was thinking might happen. Also it helps to put a heat gun on that tote when trying to force thru that plastic. Man i can't wait to see that WC take off. I have 4 that wiill go into flowering room in about 1-2 weeks
I do have a small torch seeing as this has been problem for me, u r saying just heating it up a tad may allow it to stretch a tad easier?
I would try that, but em1 is some serious stuff, it's completely made hot glue vanish in the past when I used it to hold the wick in place! with that on my mind I'm worried about using that then half way through flower and it dissolves next thing I know the entire grow room is flooded!
Exactly just soften it up a little. The silicone might hold but it is a week link. I am sure you can find some use for the totes.
oh yea, I need more worn bins to expand them, plus my soil is always multiplying! so I duck tape the holes, and it will hold soil just fine! tons of options! just sucks bc I need sips built!
in use a black gorilla tape, it's expensive but works for everything! if I had to include duck tape the wife to a wall lol!
Better yet over their mouth( hope there is no wife's in this conversation)
Probably the same product. Can you tear the gorilla with you hands like reg duct tape?
I can other ppl cant, lmfao, I expected the old lady not to be able to do it, but had a buddy helping and he couldn't tear it either! needless to say he got a new nickname lol
I haven't used the 3M yet, but they make some good stuff. I'll try it out. Now the Gorilla tape- X2 on that. That's some nasty, sticky stuff..... Lol
I did not think it would take long for that WC to shoot back up. i am puffing on some Banana Berry distillate THC 88% thru a vape pen. smoking anything is to rough on my lungs( probable the 35 years of Mexican brick weed i smoked). I have been out in the garage checking out my new toy. I sure got a lot of studying to do to figure out how to drive this baby! This unit is from Lowtemp-plates out of Denver CO
