ebb and grow when do i move rockwool cubes to pots w hydroton?
- Thread starter monster kush
- Start date
Realclosetgreenz
Well-Known Member
Only use water till plants are 4" tal then start nute solution at 250ppm. When using rockwall regularly flush system between nute changes with a low-strength nute solution to prevent salt buildup. Eventually get to about 800-1300ppm strength nute solution.
wyteberrywidow
Global
Put your babies and run the system leave it with no nutes for now add a low dose in a week or 2.
peteman990
Active Member
Is there a reason why you posted this on multiple forums AND multiple sections of every forum? I've seen this post on THREE different sections on this site. I hope you don't get any answers. Seriously, FIGURE OUT WHERE TO POST, THINK, then post it in the correct section.
GreenThumbSucker
Well-Known Member
When they all have roots coming out of the bottom, put them in the system.
Initially flood twice a day, when they get a little bigger, flood 3 or 4 times a day.
relax peteman, just a fellow smoker looking for a little advice. We are all here to help each other.
monster kush
Member
sorry for multiple listings needed answer fast thanks for replies
peteman990
Active Member
It's cool man, it was the 3rd time I had seen that that day so just got a lil peeved. I wish you best of luck kush.
GreenThumbSucker
Well-Known Member
This is an important point too: Run them with low nutes once you put them in the hydroton until you see roots coming out the bottoms of the pots, then turn the nutes up to 500 or 600 PPM
Plants with roots can handle nutes
I suggest reading Al B Fuct sticky on harvest every 2 weeks. He knows also about ebb and Flow. Personally I take my rock wool cubes, that are two week old clones, stick them in 6 inch pots of hydroton and put them in the ebb and flow system with full nutes. Works for me, but everyone has their own opinions.
Similar threads
