Between cost and laziness I was planning on using hlg 120 c350s for my strips. I keephaving a lingering feelings the far red/uva strips is going to get too much power. It’s going to cost an extra 200 to put them on separate drivers.Do y’all think it’s worth the extra effort to put the uva/730 strip on its own lower powered driver to make its output around 10 percent. With my current set up all 4 strips would split the driver output. And any suggestions for red strips that’s in the US other then rapid
Driver selection time supp lights
- Thread starter budman410
- Start date
Between cost and laziness I was planning on using hlg 120 c350s for my strips. I keephaving a lingering feelings the far red/uva strips is going to get too much power. It’s going to cost an extra 200 to put them on separate drivers.Do y’all think it’s worth the extra effort to put the uva/730 strip on its own lower powered driver to make its output around 10 percent. With my current set up all 4 strips would split the driver output. And any suggestions for red strips that’s in the US other then rapidPlaying around with my quantum meter, the current driver I have pull 100 watts from the wall and put out around 100 on my meter. I’m going to go ahead and buy separate drivers. For my left over boards I’m looking at these solderless stars as an option. Planning on trying some out soon on this huge 4x4 fixture I have
Similar threads
