Cooling Quantum Boards?
- Thread starter Freakish
- Start date
Some 6 inch fans are about worthless, like some of the cheap clip on 6 inch fans. Barely move any air on high. That could be part of your issue. Also seen a few threads about the 304s were it was stated they tend to run a bit warm. But I'm new to LED lighting, so take that for what it's worth.
Budzbuddha
Well-Known Member
This is why I like Dimmable drivers .. I can drop load slightly and get it running cooler.
I am running 4 QB with cobs and still am able to touch slates. Just oscillating fans in 3x3 on a 18/6 cycle. As stated some clip fans are less than effective but you " could " technically have two blowing laterally across boards from each end of sink. But usually dropping power slightly will rope it in.
Which slate heatsink ?
Do you have pics of your setup ?
I am running 4 QB with cobs and still am able to touch slates. Just oscillating fans in 3x3 on a 18/6 cycle. As stated some clip fans are less than effective but you " could " technically have two blowing laterally across boards from each end of sink. But usually dropping power slightly will rope it in.
Which slate heatsink ?
Do you have pics of your setup ?
Aunt Bob
Member
You must have those wired parallel then so 1050ma each board? If so they will be fine.hows the temps in the tent ?
Similar threads
