630w CMH sog hydro grow

Deltagreen

Well-Known Member
Day 13F
These plants have more than doubled in size. I'm definitely going to have to install another net and bend the tops. Everything looks super healthy though. Thinking about looking into another 630 cmh that has a remote ballast. I would be able to go up another 8" if the ballast and cord weren't in the way. 20180926_231947.jpg 20180926_231938.jpg
 

Deltagreen

Well-Known Member
A lot of these cmh ballast are attached to the hood. I'm looking into the one that have a horizontal ballast. Honestly the ballast doesn't give off much heat, just sucks its vertical wasting space
 

pinner420

Well-Known Member
Don't buy the cheap one from growers house. Com... dual or single.... pop over to club 315 and see what's shaking for reliability... burnt 2 this week...
 

Deltagreen

Well-Known Member
Week 2 of Flower day 14
So last night was the 2 week mark for flowering. Plants are ranging from 34" to 37" in height. 10" to 13" more than I would have liked. Some have grown more than double in size since the 12/12 flip and I don't think they're done, I have a feeling they're going to stretch some more. I tried putting another trellis net, but it was to much of a pain in the ass. I ended up using garden wire ties, I tied the middle of the stalk to one side of the square on the existing netting, then I bent the tops in the opposite direction has far as they can go. I gave them another defoliation cause they were getting out of hand. Tonight I will be changing my reservoir and I will give another update.
20180928_010003.jpg 20180928_010022.jpg 20180928_010012.jpg
 

SunPlix CMH

Well-Known Member

SunPlix CMH

Well-Known Member
Week 2 of Flower day 14
So last night was the 2 week mark for flowering. Plants are ranging from 34" to 37" in height. 10" to 13" more than I would have liked. Some have grown more than double in size since the 12/12 flip and I don't think they're done, I have a feeling they're going to stretch some more. I tried putting another trellis net, but it was to much of a pain in the ass. I ended up using garden wire ties, I tied the middle of the stalk to one side of the square on the existing netting, then I bent the tops in the opposite direction has far as they can go. I gave them another defoliation cause they were getting out of hand. Tonight I will be changing my reservoir and I will give another update.
View attachment 4206735 View attachment 4206736 View attachment 4206740
Looks like the light is not evenly distributed. Maybe I am wrong.
 

Deltagreen

Well-Known Member
Looks like the light is not evenly distributed. Maybe I am wrong.
It is, my plants are raised off the floor to allow drainage out the tent. That's one of the reasons I'm running out of space. I also should have vegged for 1 week instead of 2. This is my first run in over 10 years, but also first time in a tent.
 

Deltagreen

Well-Known Member
The nutrients I am using for week 3 of flowering are;
GH Floranova Bloom
GH Rapid Start
GH Koolbloom
GH Diamond nector
GH Floricisious plus
GH Flora Blend
GH Armor Si
GH Calimagic
CE Sugaree
Ph is at 6, ppm is at 880
 

Deltagreen

Well-Known Member
Per my General Hydroponics feeding chart my ppm should be between 1100-1650. I'm still not grasping on how to raise it. I have a 20 gallon reservoir, I use RO water, pH is 6, any one know how to go about this? Any advice would be greatly appreciated.

Here's how much of everything I put per gallon;
GH Floranova Bloom- 7.5ml
GH Rapid Start- 1ml
GH Koolbloom- 2.5ml
GH Diamond nector- 5ml
GH Floricisious plus- 1ml
GH Flora Blend- 5ml
GH Armor Si- 2.5ml
GH Calimagic- 5ml
CE Sugaree- 5ml
Ph is at 6, ppm is at 880
 

trenton735

Active Member
Per my General Hydroponics feeding chart my ppm should be between 1100-1650. I'm still not grasping on how to raise it. I have a 20 gallon reservoir, I use RO water, pH is 6, any one know how to go about this? Any advice would be greatly appreciated.

Here's how much of everything I put per gallon;
GH Floranova Bloom- 7.5ml
GH Rapid Start- 1ml
GH Koolbloom- 2.5ml
GH Diamond nector- 5ml
GH Floricisious plus- 1ml
GH Flora Blend- 5ml
GH Armor Si- 2.5ml
GH Calimagic- 5ml
CE Sugaree- 5ml
Ph is at 6, ppm is at 880
Maybe you have a hard water chart? Either way your plants looks healthy. I don’t think we need as much as most ppl say we need for most applications tbh. Some strains can take high ppm and some can’t. But I haven’t noticed a diff in yields when I was at 1300 ppm vs 900. Except some plants burn with higher ppm. Some don’t react negatively but I’ve still ended up with the same avg yield. Most likely a waste of nutrients lol....
 
Top