Recent content by smellmyfinger

Does anyone know where that humidity dome and tray came from????? It's in the picture in the first post, has a maroon bottom with some type of grating material on the bottom. The clear lid has the green vents in the sides. It looks like a very nice little setup. Never seen this at any grow...

Where did you get that humidity dome and tray?! LOVE IT! Haven't seen that before at any of the grow shops. It looks smaller than the standard flat.

Keep the light back. I don't know if I'd have the light that close if they were mature. You could use a couple CFL's or put that 400 watt bulb a few feet away until they start to get some leaves on them. It looks like they got fried.

Use what you have, the cubes and the powder or gel. I find that they die if the temp is too cold. Try to use a light close to the clones in your container with the dome so the heat from the light keeps them warm. Keep the cubes moist but not soaking wet. My problems with cloning have been the...

Any comments on this would be appreciated. I didn't find anything on this, surely someone is an expert.

If using a waterfarm, or similar, does it run all the time? What schedule are people using? Should it come on every hour, 2 hours, all the time? Also should it be off at night or no?

If guys like this keep talking to the press you won't have to worry about it. Also a bill has been introduced making the state the grower. Phone your Colorado law maker now and make sure they know where you stand on this issue! Link to idiot with big mouth and pot leaf hat...

The sooner the better. Right after it sprouts if you can. Roots grow fast and will find the bottom sooner than one thinks.

Try it, you won't hurt anything. You may have to switch the wires around and see what works best. Some fans have a visibe thermister that can be jumped for increased speed.

If you want to re veg you can cut all the buds off and enjoy them. It WILL veg again if put under 18 hour light. Just leave some leaves and it will be fine. You could even take clones from it before forcing flower again. Give it a few weeks under 18 hour light and you'll be amazed what happens...

A large bale of sunshine 4 mix will fill 20 3 gallon pots and I think costs around $35.

Dura72 good idea with drilling little holes, I hadn't thought of that. Yes I've used holesaws, just nothing close to 4 inch and never in steel. Also I don't know what happens when the holesaw is almost finished with the cut and binds up. This has happened to me before with large drill bits and...

You may have to say goodbye to a few plants and focus on two remaining good ones, or one remaining good one. Most will say the tin foil should go. Get white poly or flat white paint or mylar should be used. Plan on 3 feet of vertical growth above the container unless you will be tying them down...

The electric heater may be the best bet. Look at ebay for "greenhouse thermostat" and then buy a small heater to plug into it. I don't think the thermostat on a cheap heater is worth much (mine was +/- 7 degrees) and an add on thermostat will keep the temp within 2 degrees. I would hook a small...

No I'm asking how to best cut a 4 inch hole in a STEEL, AND if 4 inch would be the way to go. 4 inch may be overkill for a cabinet of this size. Currently it will house CFL's but I would like to upgrade to HID in the future and it appears the smallest vent fittings are all 4 inch. Only someone...