Yeah I only bought Hydroton because it was so expensive online but it ended up just slightly cheaper because they didn't have anything other than a huge 25L bag of it..
They wanted like $9 for a bucket and $7 for duct elbows which I found at home depot for 3 each. Thank you for all your help! I just have one more main step.. the actual scrog net/PVC assembly.
I also can't PM anyone, I think my account is too new. If you could please check out
my other thread here, that would be super helpful man!
And thank you about the information on the diaphragm and electric motors. I was pretty sure it would be fine, but I just thought I'd make sure since it was pretty pricey for an air pump.
I actually decided to put it on an upside down bucket since I have plenty of floor space and I'm going for scrog. Here are a few pics.. almost there!!
I totally overestimated the amount that would be lost due to bucket and hood/filter... also originally had a different plan for filter. But luckily got the lamp to be pretty much dead center.
(check out intake hole at bottom and lamp location)
Had the 400w HPS running for about 2 hours and got around 75 but it was from 10pm to 12pm. Also need to get some more ventilation for intake, just had some spare duct but I need a 90 degree register boot and to seal up intake.. it was just a test run, hope it turns out better once it's all dialed in.
SUPER EXCITED! thank you everyone here at rollitup for helping me out so far.. this has been so great.
if anyone happens to know about scrog nets with PVC and height levels..
please check out my thread here.. that's the last step for me and I just need a bit more help! but better get some sleep 5am here haha thank you everyone!!