hey everyone i bought 2 packs of each buffer solution
7.01 also 4.01 also 2 packs of HI 1414 solution..to calbrate my HI
98129 meter..
ok i rinised the meter with distled water used a paper towel to tap it
and dry it off then went into CAL mode it asked for 7.01. so i put it
in the 7.01 pack...then it asked for 4.01 rinshed it off with distled
water..taped it slighty on the paper towl to dry it off put it in the
4.01 then it said ok so its calbrated...
so then i test it i rinshed the meter with distled water dry it off
with the paper towel tapeing it...then i open a new pack of 7.01 after
turning the meter off an on to make sure it cleared i waited untill
the ph number got to 0 then put it in i keep getting differnt
readings..then i did the same with the 4.0 same thing happen..i also
CAL then PPM in us mode with HI1413 buffer solution and cleaned off my
meter dry it again with the paper towel and my ppm reads 703 when
putting it into a new pack of buffer solution here are my reading from
the ph..is this a bad meter or the best im gonna get to being close?
1st in the 7.01...7.10 7.16 7.12 7.17
2nd the 4.01...4.15 4.11 4.12 4.10 4.09 4.05 4.07
im thinking ive got a bad meter from Fleabay...my areo cloner is
reading 7.13 ouch...any ideas mabe im doing something wrong buffer
settings?
7.01 also 4.01 also 2 packs of HI 1414 solution..to calbrate my HI
98129 meter..
ok i rinised the meter with distled water used a paper towel to tap it
and dry it off then went into CAL mode it asked for 7.01. so i put it
in the 7.01 pack...then it asked for 4.01 rinshed it off with distled
water..taped it slighty on the paper towl to dry it off put it in the
4.01 then it said ok so its calbrated...
so then i test it i rinshed the meter with distled water dry it off
with the paper towel tapeing it...then i open a new pack of 7.01 after
turning the meter off an on to make sure it cleared i waited untill
the ph number got to 0 then put it in i keep getting differnt
readings..then i did the same with the 4.0 same thing happen..i also
CAL then PPM in us mode with HI1413 buffer solution and cleaned off my
meter dry it again with the paper towel and my ppm reads 703 when
putting it into a new pack of buffer solution here are my reading from
the ph..is this a bad meter or the best im gonna get to being close?
1st in the 7.01...7.10 7.16 7.12 7.17
2nd the 4.01...4.15 4.11 4.12 4.10 4.09 4.05 4.07
im thinking ive got a bad meter from Fleabay...my areo cloner is
reading 7.13 ouch...any ideas mabe im doing something wrong buffer
settings?