Questions are at the bottom. First part is for ideal of my setup.
So I got my cabinet finish. It is located in my garage. It is full basement garage so upstairs is on block walls that has no insulation. Ceiling has insulation only. My cabinet is located under the stairs going up to house part. Room is 4 1/2 feet wide and 8' long, no door. There is no insulation under the stairs and a section that goes to block wall. Cabinet is 2x2x4, sitting on 1x6x3', I used osb to build box then I hung drywall. Painted with flat white. 5 23w cfl in it. 120mm intake light blocking box built around it and a 7 1/2 inch blower fan for exhaust venting through the top. (this blower fan came off air hockey table.) 3' muffler built inside particular board box with polyfill inside box. Carbon scrubber on inside of box and a small one inside muffler tube and a 2x4 inch inside the 6" duct. I Have 6" duct running from my muffler tube to the utility room upstairs. It has been unhooked every sense I moved into the house. So room stays hot cause we keep the door closed.
Question 1- By me running it to hot utility room is it a good venting way to avoid flir detection, for venting?
Question 2-Can flir detect the heat from my grow box. ( I used ir laser temp gun. Box is around 8 to 10 degrees different then the room walls and floor.)
I live in subdivision that has 3 city cops and 2 sheriffs that live within 1 football field length to Maybe a quarter to half mile radius. Basically all around me.
Question 3- do you think I can pull this off or just plain stupid?
Sent from my iPad using Tapatalk
So I got my cabinet finish. It is located in my garage. It is full basement garage so upstairs is on block walls that has no insulation. Ceiling has insulation only. My cabinet is located under the stairs going up to house part. Room is 4 1/2 feet wide and 8' long, no door. There is no insulation under the stairs and a section that goes to block wall. Cabinet is 2x2x4, sitting on 1x6x3', I used osb to build box then I hung drywall. Painted with flat white. 5 23w cfl in it. 120mm intake light blocking box built around it and a 7 1/2 inch blower fan for exhaust venting through the top. (this blower fan came off air hockey table.) 3' muffler built inside particular board box with polyfill inside box. Carbon scrubber on inside of box and a small one inside muffler tube and a 2x4 inch inside the 6" duct. I Have 6" duct running from my muffler tube to the utility room upstairs. It has been unhooked every sense I moved into the house. So room stays hot cause we keep the door closed.
Question 1- By me running it to hot utility room is it a good venting way to avoid flir detection, for venting?
Question 2-Can flir detect the heat from my grow box. ( I used ir laser temp gun. Box is around 8 to 10 degrees different then the room walls and floor.)
I live in subdivision that has 3 city cops and 2 sheriffs that live within 1 football field length to Maybe a quarter to half mile radius. Basically all around me.
Question 3- do you think I can pull this off or just plain stupid?
Sent from my iPad using Tapatalk