unknown1231
Well-Known Member
The final stage of cannabis growing from cutting and trimming your branches to drying and curing your buds determines the quality of the pot you produce. These easy-to-follow harvesting instructions will help lock in flavor and potency for the best smoke youve ever grown.
Cutting Properly processing cannabis at harvest is a craft that must be mastered in order to enhance and preserve the psychoactive properties, taste and appearance of the finished product. Many talented growers neglect to implement some of the following techniques, resulting in buds that fail to reach their maximum potential.
Inadequate or poor handling after harvest is the biggest cause of mediocre or poor-quality cannabis. This problem is compounded by the fact that most growers feel their pot is better than everyone elses. Try telling a grower friend that he or she could do a better job trimming and curing; this will usually result in the end of a friendship. However, a good trim and cure can mean the difference between green-tasting, hard-to-burn nugs and pleasurable, smooth, clean-burning dank buds.
There are two basic methods used by growers to harvest their cannabis: cola harvesting (cutting the buds from the branches individually) and harvesting the entire plant (cutting it off at the main stalk near the bottom). The majority of growers find individual cola harvesting to be superior, for several reasons.
Some cannabis strains exhibit varying finishing times on the same plant. For example, the top colas may ripen while lower branches are still developing. Tops can be removed to expose the lower branches to light, thus allowing the lower buds to ripen further.
Individual harvesting and drying of branches works faster than drying a whole cannabis plant. When a cannabis plant is harvested, the stomata on the surface of the leaves and calyxes will start closing off, allowing only small amounts of water vapor to escape. This forces the excess moisture stored within the stems/stalks to exit through the cuts youve made on them when harvesting. The fewer cuts for water vapor to exit through, the longer the drying time.
Trimming
For highest-quality results, its best to trim all excess leaves from the colas/buds upon harvest, while the foliage is still rigid and fully hydrated. Its very important to remove as many leaves protruding from the bud as possible. These leaves still contain chlorophyll, which will adversely affect the taste of your finished product. Some growers prefer to let these leaves curl around the bud for the sake of appearance; however, theyre sacrificing the taste and smoothness of the smoke.
Trimming is a tedious job and requires a great deal of patience, self-discipline and the proper supplies. Its important to have a good pair of scissors (a $10 pair of hair-cutting shears will do the job perfectly). Its nice to have a bowl or basket nearby for the shade leaves and a separate container for the sugar leaves (I like to separate them because I later use the sugar leaves for hash- and butter-making). A table, comfortable chairs and good lighting are also important for the trimming process. Try to sit up straight, set goals and take breaks; trimming a full crop can mean several days worth of work, even for the experienced trimmer.
Drying
The drying process precedes the final harvesting stage of curing. Drying is simply the act of removing the excess water from the cannabis. Leave the buds on the stems and hang each individual branch on a string or hanger of some sort. Its best to dry the buds in a place that has indirect lighting and adequate air circulation.
A fan is good to have in the room, but dont point it directly at the hanging buds. Allow the buds to dry until theyre crisp on the outside and the stems are still pliable. Because the stems contain so much residual moisture, its best at this time to remove the buds and place them in a large bowl or on a screen or tray. Hanging and drying time will vary due to climate and humidity.
When buds dry slowly, it makes for a smoother cure. If buds are dried too quickly, a harsher smoke could result. With slowly dried buds, the humidity remains closer to the humidity inside the stomata. If cannabis is dried too rapidly, the green taste will remain in the finished product.
Drying times are usually from five to 10 days; it varies according to the temperature and type of heat in your home, as well as the ambient humidity, airflow and the density of your buds.
Curing
Cannabis continues to cure after its harvested, while its drying and even after its put in a jar. Just like a fine wine or gourmet coffee beans, marijuana needs to be cured to achieve the rich, smooth, robust taste that lingers on your palate and in your brain. During the curing period, the cannabinoid acids go through the process of decarboxylation into the psychoactive cannabinoids, and the terpenes will isomerize to create new polyterpenes.
Just as with any other fruit, when cannabis is harvested, the fruit or bud isnt dead; it continues to metabolize. Pick a tomato from your garden while its still partially green and set it on a windowsill; itll continue to ripen for days. The same is true of a fresh banana. As the banana ages, the peel will turn a darker yellow, and the fruit inside will become softer and have a sweeter flavor. The more robust flavors and tantalizing fragrances of cannabis begin to appear as the chlorophyll and other pigments break down.
When the small stems that remain under the buds are dry enough to snap, and the buds themselves are dry enough to smoke, its time to begin the final curing process. Make sure your cannabis is completely dry before putting it in a sealed jar or container. Sealing wet cannabis in a jar or container will result in mold, rendering the weed unsafe to smoke.
Use glass canning jars (i.e., Mason, Ball or Kerr) to cure and store your finished product. Freezer bags can also be used for storing cannabis, but glass is always preferred. Dont store your cannabis in sandwich bags or anything made of a similar plastic; the buds will become too dry and lose potency.
Its important to open the jars occasionally to let in oxygen needed for the curing process, as well as to allow gases built up from the curing process to escape. During the first three days of curing, I open the jars once a day. After that, open your jars twice a week for two weeks, then once more after the first month. At this point, the curing process is basically complete, but the buds will continue to mature and acquire more delicate flavors with time if stored properly.
Store your jarred, cured cannabis in a cool, dark place to help slow the breakdown of the cannabinoids. Although cannabis needs oxygen through the metabolizing/curing stage, at this point oxygen will have an adverse effect on the already-cured cannabis, since it causes the breakdown of THC into CBN.
The implementation of the simple steps listed above will make your dank a legend among your friends. Imagine their surprise when you break out some buds from a three-year-old harvest and they smoke and taste better than ever. Theres no limit to the superb qualities of aged cannabis when its properly dried, well cured and suitably stored.
Text by MzJill & MG Imaging [hightimes]
Cutting Properly processing cannabis at harvest is a craft that must be mastered in order to enhance and preserve the psychoactive properties, taste and appearance of the finished product. Many talented growers neglect to implement some of the following techniques, resulting in buds that fail to reach their maximum potential.
Inadequate or poor handling after harvest is the biggest cause of mediocre or poor-quality cannabis. This problem is compounded by the fact that most growers feel their pot is better than everyone elses. Try telling a grower friend that he or she could do a better job trimming and curing; this will usually result in the end of a friendship. However, a good trim and cure can mean the difference between green-tasting, hard-to-burn nugs and pleasurable, smooth, clean-burning dank buds.
There are two basic methods used by growers to harvest their cannabis: cola harvesting (cutting the buds from the branches individually) and harvesting the entire plant (cutting it off at the main stalk near the bottom). The majority of growers find individual cola harvesting to be superior, for several reasons.
Some cannabis strains exhibit varying finishing times on the same plant. For example, the top colas may ripen while lower branches are still developing. Tops can be removed to expose the lower branches to light, thus allowing the lower buds to ripen further.
Individual harvesting and drying of branches works faster than drying a whole cannabis plant. When a cannabis plant is harvested, the stomata on the surface of the leaves and calyxes will start closing off, allowing only small amounts of water vapor to escape. This forces the excess moisture stored within the stems/stalks to exit through the cuts youve made on them when harvesting. The fewer cuts for water vapor to exit through, the longer the drying time.
Trimming
For highest-quality results, its best to trim all excess leaves from the colas/buds upon harvest, while the foliage is still rigid and fully hydrated. Its very important to remove as many leaves protruding from the bud as possible. These leaves still contain chlorophyll, which will adversely affect the taste of your finished product. Some growers prefer to let these leaves curl around the bud for the sake of appearance; however, theyre sacrificing the taste and smoothness of the smoke.
Trimming is a tedious job and requires a great deal of patience, self-discipline and the proper supplies. Its important to have a good pair of scissors (a $10 pair of hair-cutting shears will do the job perfectly). Its nice to have a bowl or basket nearby for the shade leaves and a separate container for the sugar leaves (I like to separate them because I later use the sugar leaves for hash- and butter-making). A table, comfortable chairs and good lighting are also important for the trimming process. Try to sit up straight, set goals and take breaks; trimming a full crop can mean several days worth of work, even for the experienced trimmer.
Drying
The drying process precedes the final harvesting stage of curing. Drying is simply the act of removing the excess water from the cannabis. Leave the buds on the stems and hang each individual branch on a string or hanger of some sort. Its best to dry the buds in a place that has indirect lighting and adequate air circulation.
A fan is good to have in the room, but dont point it directly at the hanging buds. Allow the buds to dry until theyre crisp on the outside and the stems are still pliable. Because the stems contain so much residual moisture, its best at this time to remove the buds and place them in a large bowl or on a screen or tray. Hanging and drying time will vary due to climate and humidity.
When buds dry slowly, it makes for a smoother cure. If buds are dried too quickly, a harsher smoke could result. With slowly dried buds, the humidity remains closer to the humidity inside the stomata. If cannabis is dried too rapidly, the green taste will remain in the finished product.
Drying times are usually from five to 10 days; it varies according to the temperature and type of heat in your home, as well as the ambient humidity, airflow and the density of your buds.
Curing
Cannabis continues to cure after its harvested, while its drying and even after its put in a jar. Just like a fine wine or gourmet coffee beans, marijuana needs to be cured to achieve the rich, smooth, robust taste that lingers on your palate and in your brain. During the curing period, the cannabinoid acids go through the process of decarboxylation into the psychoactive cannabinoids, and the terpenes will isomerize to create new polyterpenes.
Just as with any other fruit, when cannabis is harvested, the fruit or bud isnt dead; it continues to metabolize. Pick a tomato from your garden while its still partially green and set it on a windowsill; itll continue to ripen for days. The same is true of a fresh banana. As the banana ages, the peel will turn a darker yellow, and the fruit inside will become softer and have a sweeter flavor. The more robust flavors and tantalizing fragrances of cannabis begin to appear as the chlorophyll and other pigments break down.
When the small stems that remain under the buds are dry enough to snap, and the buds themselves are dry enough to smoke, its time to begin the final curing process. Make sure your cannabis is completely dry before putting it in a sealed jar or container. Sealing wet cannabis in a jar or container will result in mold, rendering the weed unsafe to smoke.
Use glass canning jars (i.e., Mason, Ball or Kerr) to cure and store your finished product. Freezer bags can also be used for storing cannabis, but glass is always preferred. Dont store your cannabis in sandwich bags or anything made of a similar plastic; the buds will become too dry and lose potency.
Its important to open the jars occasionally to let in oxygen needed for the curing process, as well as to allow gases built up from the curing process to escape. During the first three days of curing, I open the jars once a day. After that, open your jars twice a week for two weeks, then once more after the first month. At this point, the curing process is basically complete, but the buds will continue to mature and acquire more delicate flavors with time if stored properly.
Store your jarred, cured cannabis in a cool, dark place to help slow the breakdown of the cannabinoids. Although cannabis needs oxygen through the metabolizing/curing stage, at this point oxygen will have an adverse effect on the already-cured cannabis, since it causes the breakdown of THC into CBN.
The implementation of the simple steps listed above will make your dank a legend among your friends. Imagine their surprise when you break out some buds from a three-year-old harvest and they smoke and taste better than ever. Theres no limit to the superb qualities of aged cannabis when its properly dried, well cured and suitably stored.
Text by MzJill & MG Imaging [hightimes]
