Whats the best thing to cut a hole with?
- Thread starter jerkin247
- Start date
Integra21
Well-Known Member
adjustable hole saws are the best I've found. They go through the plastic lids fairly easy and allow you to cut holes for most net pots. Just remember to try a practice hole first, and make sure its the size you want before doing it to your actual tub. good cardboard will work for that. Here's a link so you get an idea what to look for, usually have at least 1 in with the drill bits and mine only cost $10 in store
http://www.homedepot.com/Tools-Hard...splay?langId=-1&storeId=10051&catalogId=10053
And here are some pics of my tub i made with a similar bit
adjustable hole saws are the best I've found. They go through the plastic lids fairly easy and allow you to cut holes for most net pots. Just remember to try a practice hole first, and make sure its the size you want before doing it to your actual tub. good cardboard will work for that. Here's a link so you get an idea what to look for, usually have at least 1 in with the drill bits and mine only cost $10 in store
http://www.homedepot.com/Tools-Hard...splay?langId=-1&storeId=10051&catalogId=10053
And here are some pics of my tub i made with a similar bit
thats good but if you cant aford that just heat up a knife and cut away it works
I
Illegal Smile
Guest
I cut them with a utility knife but I hear those roto zip saws work well. But how many holes do you have to cut to make one of those worth the investment?
hotboxhatchback
Active Member
+1 for utility knife - just be sure to cut in a direction that's away from your flesh or you'll loose a corner of your totin' chit.
katwoman2012
Well-Known Member
We have several holes cut in each of our three Sterlite cabs for ventilation. We bought a Dremel 4.8V cordless drill that came with a set of bits for about $25 at Walmart. Works wonderful and can just be plugged in for charging. We also used it to drill small holes for screw-in hooks holding all the chains for lights and fans up. Great product!!!
omkara
Member
If you need to cut a hole for your 3.5in. net pots you can use a 3in. hole saw, you need the extra 1/2 inch for the lip of the net pot to hang. If you cut a 3.5 inch hole your net pots will just fall through the hole.
Here's a picture of mine.
I think the adjustable hole drill that matteodvr posted the link for is even better than the 3in. hole saw I purchased because you get more bang for ya buck with being able to make different size holes.
Integra21
Well-Known Member
yes, a good adjustable is the most cost effective if your going for perfect circles. I used a hair dryer and razorblade for my first lid and it took a little over an hour to put 10 holes in the lid and made my hand hurt like a s.o.b. I re-did the tub(pictures from earlier post) and used an adjustable from home Menards that cost $7 and I did the new 10 holes in under 5 minutes with no discomfort. Also got perfect circles which is much harder to do with any bladed weapon...
