roll.it.up
Active Member
how much pot do you suggest putting in each fire cracker?
what gets you highest with least weed
- Thread starter i see a whole new world
- Start date
how much pot do you suggest putting in each fire cracker?stevesmokesweed
Well-Known Member
wouldn't just swallowing a small bud do the same thing ?
theollister
Active Member
nope, thc needs to be extracted by process of heat to be effective.
Fuck you.. most ignorant thing i have ever read. btw salvia is not 'legal weed' in any sense. it is a completely different type of high and shouldnt be messed with by inexperienced people.
F
FallenHero
Guest
make a gravity bong. It gets you killer rips with just a`little weed.
you'll need
2 liter bottle
original bottle cap
sharp knife
a bucket (somewhat bigger than your bottle)
water
tin foil
your weed
lighter
cut the bottom of your 2 liter bottle out leave as much of the bottle intact as possible.then take your cap and cut a hole out of the top and put your foil on top of it and form a bowl to put your weed in, poke small holes for the smoke to go through.put the cap back on your bottle.next put your bottle in your bucket and fill the bucket until its almost to the top of the bottle and leaving a little bit of air still. put your weed in the tin bowl.put your lighter to the weed and and very *slowly* pull up the bottle, keep your lighter to the weed when pulling up. you will see the smoke filling the bottle, and when you can't pull it up any longer becuase the smoke will come out of the bottom if the bottle gets out of the water, screw off the cap and put your lips around the top and push the bottle back down into the water.hold it in as long as possible.
if that wasn't descriptive enough you can find plenty of stuff about in on google.
hope that helps
this is my suggestion also, except screw the foil, i simply melt a socket piece into a cap, and it lasts me years. my suggestion is to find a small socket piece, you goal is 1 pack 1 pull/hit, so it should be small, my socket piece is a 7/32, this has worked the best for me, no screen needed. cut a hole directly in the center of the cap, and keep it clean, you can even use a drill, but make sure it's just a bit smaller than the socket, so you have to press hard to pop it in, then, you'll need a torch lighter, a regular lighter takes extremely too long to heat it up properly, the lighter will get too hot. Anyhow, heat just the metal piece with a torch lighter, not the plastic! Right as you see the plastic start to "glisten" around the metal piece, take the lighter off, and the bowl piece should melt in snug quite nicely. if you overheat it, it's ok.. just get a new cap - any try again. pepsi caps are best in my area... the liner comes out properly, coke's does not. you don't want plastic burning when you hit this thing, use a bic only, not the torch, when smoking, this is bad for you.
as far as filling the water up, i reccomend filling it only to the line where the bottle starts to get smaller in diameter, this is lessen your chances of getting watering in your mouth if you go to far. the water moves much faster up that smaller area and it WILL catch you off guard and make your puke.
hope i helped.
