What could be the cause?

ManishWayz

Active Member

• May 2, 2012

• #1

I'm not to sure what the problem is but I followed the nutrient mix for a 5gal res, and after about 1 week of the nuts being in the dwc the tips are changing. What could be the problem. O, I'm running a DWC setup. (CES 3 part) And I'm omly running 2x 150 watt hps lights

 

+ WitchDoctor +

Well-Known Member

• May 2, 2012

• #2

Looks like nutrient burn. Every plant is a little different, so try backing down to half strength on the nutes and then see if you can move up from there.

 

TriPurple

Well-Known Member

• May 2, 2012

• #3

I agree the WitchDoctor. First sighs of nute. burn

 

ManishWayz

Active Member

• May 2, 2012

• #4

What should I do at this point due to the plant flowering?

 

90cody

Active Member

• May 2, 2012

• #5

add fresh water to the res, if u have it full take some of the nutes out, such as a gal of nutes replace with ph adjusted water, it will lower the PPM quite a bit... since u caught nute burn early, it should not be an issue, IF you see the yellowing on the outer leaves progress after 3 days to a week, do a complete flush and a flushing agent to remove the salt build up and then start with a 3/4 solution.

good luck
-cody

 

ManishWayz

Active Member

• May 2, 2012

• #6

Thanks everyone!

 

90cody

Active Member

• May 2, 2012

• #7

ManishWayz said:

Thanks everyone!

Click to expand...

keep us updated of what happens