Technaflora Nutrients - Anyone Use?
- Thread starter Livetowin
- Start date
dannyboy602
Well-Known Member
I used them in veg stage at first...burnt a little...cut back strength in half and was ok then
In flower I use them full strength. Especially the sugar daddy.
elduece
Active Member
When transitioning to flower if using soil/soiless, I'd continue to use the veg recipe mix for another week or two at full strength under MH grow lights. Or you'll get early leaf drops with this flora recipe. Foliar feed with Awesome blossoms with 1/8 -1/4 strength of recommended foliar dosage rate as per label during this transition period every two three days. I like to use 1/2 strength DM liquid light/saturator and little molasses into this mix too. After two weeks, begin the flower recipe at half strength, next watering use another half strength instead of plain water then go water, water, feed -IMPORTANT!
Remember, Boost goes into the plain water before everything else.
Remember, Boost goes into the plain water before everything else.
Livetowin
Active Member
Boost is one I've been burning through, so much that I've cut it out of my vegging plants (they're big enough as is), and about 3/4 Srength in flowering just because it goes so quick.
Question: After 2-3 days my res 5gal bucket is nearly dry (1 gal left) and the PPM shoots up to 1800+, so I now have been adding water everyday to level out the PPM, but if I add more nutes in the middle of the week, which ones do you suggest?
And, Awesome Blossoms in the res? Or just foliage feed?
elduece
Active Member
Sorry I have no real experience in hydro. I suppose you could continue giving it water to bring the concentration down during the week but replace you should that res. every week. But with Awesome Blossoms, I foliar feed them fo rth efirst during the transition every three days while continuing the veg formula.
Livetowin
Active Member
Heres a pic of my 1st grow, all technaflora nutrients.
The problem I've had is because there are so many different bottles of stuff to use, finding out what's causing certain problems can be time consuming and difficult. I dunno, i'm going to probably switch to a different nutrient line after this
Thanks dude. Nice looking plants. Did you follow the recipe? Peace, jetheadHeres a pic of my 1st grow, all technaflora nutrients.
View attachment 1579594
The problem I've had is because there are so many different bottles of stuff to use, finding out what's causing certain problems can be time consuming and difficult. I dunno, i'm going to probably switch to a different nutrient line after this
whodatnation
Well-Known Member
Iv been using technaflora for 2 grows and love it. Your ppms went up like that because they are too high to begin with IMO... I bet your ph is dropping too... This may be because the plants are drinking more water and eating less nutes so by the time the buckets emty they have gotten everything they want and need and leaving all the leftovers wich end up being more concentrated than your original batch... Drop the ppm until it seemes to hover around the same number with a slight drift up in ph as time goes by. Its good to let the ph drift from 5.6-6.1 because they actually take up different nutes at different ph's. This is all in my personal exp so take it for what you will, and I hope it helps someone even though its a dead thread
