ph probe protector

Discussion in 'Hydroponics / Aeroponics' started by Bernie420, Dec 14, 2017.

  1.  
    Bernie420

    Bernie420 Well-Known Member

    Wanted to share my idea about how I protect my glass on my ph probe that always stays in my barrel. If you use one of these you need to do this. I just used a torch, vice grips and a nail to poke the holes in it on all the sides and make sure you put holes in the bottom so the water can drain out when you pull it out your rez. I trimmed up an old toothbrush to fit in the top to clean it.



    IMAG1724[1].jpg IMAG1722[1].jpg
     
    Last edited: Dec 15, 2017
    neved likes this.
  2.  
    neved

    neved Well-Known Member

    It’s pretty sure the best way if you wanna keep it safe also,
    The head really important,every day i just check thin wire to keep moving by my little hand shake.
    Nuce advice
     

Share This Page