KrAzEo
Well-Known Member
Ok so here is my situation so far:
I am planning, very soon, on doing TWO 4X4 tent grows with 600W HPS in each. Following is what I am thinking of ordering so far:
Hydroasis.com
I am planning on keeping the lights air cooled and seperate from the general ventilation of the tent - 6" ducting coming in from outside the tent and into input of hood...then out the tent and want both tent's bulb-cooling outputs going to a "Y" splitter and being exhausted by the same (inline) fan, for which I will have a speed controller. Same setup for general ventilation except the addition of an active carbon filter on the end and a bigger fan.
Is the 240 CFM fan with speed control adequate to keep the lights cool? If not what would be?
The tents are 7' tall so have an area of 112 each...so 224 cubic feet total between the two. Is the 400 CFM fan enough to ventilate the two? If not what would be and what interval ratio would you recommend I run it (OFF 4mins ON 2mins, etc.)?
Would a 470 CFM carbon can be sufficient for both these tents?
Does anyone have experience with these tents? Is there anything they don't come with that they should/ I should need?
Sorry for a million questions but I am very excited and don't yet have any experience actually growing indoors because I haven't had a chance/private space until now.
THANKS for advice in advance!!
I am planning, very soon, on doing TWO 4X4 tent grows with 600W HPS in each. Following is what I am thinking of ordering so far:
Hydroasis.com
- 4x4 Hydrohut Silver Tents (x2) = $714.98
- Super Sun 2 Reflector w/ 6 in. Vent Fittings - Sun System (x2) = $246
- 600 HPS Digilux Bulb - 95,000 lumens (x2) = $142.94
- LEDwholesalers GYO2402 6-Inch 240 CFM Air Duct Inline Hydroponic Booster Fan (x2) = $24.20
- Milwaukee Instruments PH600AQ Ph Tester With 1 Point Manual Calibration = $19.50
- Acu Rite Indoor Humidity Monitor (x2) = $19.98
- Dundas Jafine AF625ULPZW Aluminum Foil Marked Duct, 6-Inches by 25-Feet (x2) = $29.72
- Duct Fan Speed Adjuster by Hydrofarm (x2) = $43.10
- Hydrofarm Active Air 6 inch In-Line Fan 400 CFM = $96.25
I am planning on keeping the lights air cooled and seperate from the general ventilation of the tent - 6" ducting coming in from outside the tent and into input of hood...then out the tent and want both tent's bulb-cooling outputs going to a "Y" splitter and being exhausted by the same (inline) fan, for which I will have a speed controller. Same setup for general ventilation except the addition of an active carbon filter on the end and a bigger fan.
Is the 240 CFM fan with speed control adequate to keep the lights cool? If not what would be?
The tents are 7' tall so have an area of 112 each...so 224 cubic feet total between the two. Is the 400 CFM fan enough to ventilate the two? If not what would be and what interval ratio would you recommend I run it (OFF 4mins ON 2mins, etc.)?
Would a 470 CFM carbon can be sufficient for both these tents?
Does anyone have experience with these tents? Is there anything they don't come with that they should/ I should need?
Sorry for a million questions but I am very excited and don't yet have any experience actually growing indoors because I haven't had a chance/private space until now.
THANKS for advice in advance!!