Beezcheeze
Well-Known Member
Height is an issue. Need them off the ground just a couple inches so i can clean under them and run the pipe put above the spill tray. I thinking 2" pvc with tees or elbows for legs
Need help with rdwc in grow tent
- Thread starter Beezcheeze
- Start date
RetiredMatthebrute
Well-Known Member
take a sawzall to the bucket....or you can try and build from PvC that would work as well...
I would suggest wood but its not really sanatizable...
something like this would work as well. cut 2 piece to set under bucket, PVC is washable. Would be like stickers under the bucket, would raise them exactly 2"
http://www.homedepot.com/p/Unbranded-1-1-4-in-x-2-in-x-84-in-Vinyl-Brick-Mould-Set-3-Pieces-80077-ZWS77CM1/202081502
I would suggest wood but its not really sanatizable...
something like this would work as well. cut 2 piece to set under bucket, PVC is washable. Would be like stickers under the bucket, would raise them exactly 2"
http://www.homedepot.com/p/Unbranded-1-1-4-in-x-2-in-x-84-in-Vinyl-Brick-Mould-Set-3-Pieces-80077-ZWS77CM1/202081502
Beezcheeze
Well-Known Member
I'm so ocd about my tent and it being neat and clean. I should be able to just stick 4 2" long pieces cut from a long 2" pvc under each bucket for stands. Or use like couplings even 3" ones stood up like legs under them. I think it's gonna be with pvc cause it easy to clean and cheap. Cutting buckets would be wasting money and look trashier. And I still wouldn't be able to clean under the whole setup. I thought it would be near to put it on wheels inside the tent also. I could just push it around a little bit and clean it well