np man welcome to world of indoor growing
the tent u picked apears to be a sunhut brand the hanging limits on there are pretty low
when u get the tent itself set it up and look it over to make sure no cracks in the corners or in the hanging braces
once u do that u just need to reinforce any spots u deem weak ........your tent is 45 cf
this means u can get away with a 4 inch fan and carbon scrubber
(this is assuming u are LED or T5 or COB ......HID light i would tell u use a cool tube but they are 6 inches )
so this part is simple .......in the dead middle of the tent at the highest part u will have a bar that the carbon filter hangs on .......use a Velcro one strip 2 pieces make it tight against the bar (rem to leave room on one side so the ducting can connect and go ou the port up top)
so the order is
Carbon scrubber...... ducting ........fan......... ducting........... ejection point
u want to use the flexie ducting make it as strait and tight as u can (bends and to much slack will slow the speed down).....with this tent type u should mount the fan outside the tent
https://www.amazon.com/VenTech-VT-IF4-CF4-B-Controller/dp/B005GJ7TFE
as for the light/lights u use rope ratchet hangers
https://www.amazon.com/VIVOSUN-Adjustable-Reflector-Ratchet-Internal/dp/B00P7TZNPQ
u loop the hook only one around one of the cross bars up top of the tent then use the side with the ratchet to hook to the light ....lets u move it up and down as needed for how tall the plant is .....set the light under the carbon filter so the heat raise and gets sucked out
on the bottom of the tent u will see flaps u will need to make sure they are open .........if u see the walls getting sucked in to much lower the speed with the controller in that package i linked u if it does to much even with that on low u will need to make a powered intake ....it is easy
your done with the air flower and the lights moving it to the lvl u want
just need to pick the style (hydro or soil)/type of seeds (photo or autos) u want to grow.......and pick the light style/type u want to use
