does anyone still clone in soil???
- Thread starter 711grower
- Start date
get one of thoes packs of 72 cells, green house tray with dome, rooting gel or powder when you take the clones and if your taken alot of them have a thing of water to put them in right away.
There are a few methods people use.
1 - Find the good top growth, go down about 2 to 3 nodes cut it just above the 3rd node take the lower 2 nodes off dip in rooting agent and plant in soil.
2 - take a cloe that has about 2 to 3 inches below the new growth (try to get the fresh stuff that has small leafs) dip and plant.
3 - Do #2 but strip the outter layer of skin off and dip or do that but cut the bottom to encourage more rooting areas.
There are a few methods people use.
1 - Find the good top growth, go down about 2 to 3 nodes cut it just above the 3rd node take the lower 2 nodes off dip in rooting agent and plant in soil.
2 - take a cloe that has about 2 to 3 inches below the new growth (try to get the fresh stuff that has small leafs) dip and plant.
3 - Do #2 but strip the outter layer of skin off and dip or do that but cut the bottom to encourage more rooting areas.
Jerry Garcia
Well-Known Member
I use 24oz plastic cups of Fox Farm Light Warrior under a humidity dome. Just had a sleestack x skunk clone that was 3 weeks into flower root in 5 days.
I use cheap rooting hormone from lowes. I try to find the lowest possible branch to clone.
I use cheap rooting hormone from lowes. I try to find the lowest possible branch to clone.
CrackerJax
New Member
I've never switched from soil since I never have any problems with cuttings. It's not hard to do.
livinthadream
Well-Known Member
yup stuff from wal- mart works just fine!!!
thank you for all the responces. i had some rooting gel already. i havent grown in over 10 years so i needed some refreshers. i took some clones as suggested. i had some fox farm seedling soil so i used that and put them in a humidity dome. is it necessary to spray the leaves with phd water? if so what ph should the water be?
I don't think PHed water matters for that but it does for watering but you mist the clones and the dome to keep the humid up. Some people mist the clones and plants when ever the dome is dry
The Potologist
Active Member
I have always used Fox Farm Light Warrior as a medium when cloning. I have had great success, with rooting percentages around 90% +. I use Advanced Nutrients Jump Start for clones as well as a
cloning gel. I also use distilled/ de-ionized H20. Hope this helps, and good luck. Bongs Away.
cloning gel. I also use distilled/ de-ionized H20. Hope this helps, and good luck. Bongs Away.
CrackerJax
New Member
I get 90% as well with straight soil and off the shelf powder for 5 bucks.
Weed is one of the easiest plants to propagate from cuttings.
Weed is one of the easiest plants to propagate from cuttings.
PlantManBee
Well-Known Member
Even with "hard to clone" cuts they will work in soil like this: use a light soil in a beer cup, take your cut just taller than the cup, cut off all but the top knot of leaves and insert so the cut end touches the bottom. water. of course use sterile techniques etc. you won't even need a humidity dome if you keep them in moderate light.
CrackerJax
New Member
If you can't get weed cuttings to live....you can't get any plant to live. It's by far the easiest plant I have ever worked with.
Here is a pic of 2 day old cuttings, literally JAMMED into the soil about 2 inches. I used some generic powder, although I have done it without any at all before. I just put them in partial shade and mist them every now and again. It's just that simple.
Here is a pic of 2 day old cuttings, literally JAMMED into the soil about 2 inches. I used some generic powder, although I have done it without any at all before. I just put them in partial shade and mist them every now and again. It's just that simple.
Attachments
bud nugbong
Well-Known Member
I have a 66% cloning rate w/ no hormones and in mirical grow potting soil. granted ive only tried 3 haha. but 2 of them survived and the one that died started to droop about an hour after the t-plant.
i recomend liquid rather than gel. ( i think it spreads evenly and can also be absorbed right away. cut the clones trim 2 levels of internodes from the base of the clone, scrape away some "skin" or stem, dip in root hormone/water solution and stick in the dirt.
i use a toothpick to make the hole then push the stem in a little deeper as to make sure the bottom has dirt touching all around it (air pockets and empty space around the stem is bad.) keep moist but not super wet.
i let them veg in the solo cup for about 3-4 weeks then transplant.
i recomend liquid rather than gel. ( i think it spreads evenly and can also be absorbed right away. cut the clones trim 2 levels of internodes from the base of the clone, scrape away some "skin" or stem, dip in root hormone/water solution and stick in the dirt.
i use a toothpick to make the hole then push the stem in a little deeper as to make sure the bottom has dirt touching all around it (air pockets and empty space around the stem is bad.) keep moist but not super wet.
i let them veg in the solo cup for about 3-4 weeks then transplant.
Murfy
Well-Known Member
i have a strain that is very resistant to soil cloning-
typically 2 weeks until root, i scrape the roots cut and use gel
but i have never used light warrior i will have to give that a try, for some reason my local shop doesn't ahve much in the line of light soils, lots of pumps and hose though
typically 2 weeks until root, i scrape the roots cut and use gel
but i have never used light warrior i will have to give that a try, for some reason my local shop doesn't ahve much in the line of light soils, lots of pumps and hose though
businessmen
Active Member
Make sure not to overwet your soil too, after a few days let it start drying out some. Encourages the roots to seek water.
Cali chronic
Well-Known Member
Similar threads
