Dab Rig chipped! Is it fixable?

Ca$hMonay · Jul 24, 2016

So here's the story-
My nail was stuck on my dab rig pretty good so I heated up the nail and slowly tried to take it off but instead the male attachment on the rig got stuck inside the nail and broke off. Bright side is that it isn't too bad but it's not usable at the moment. I was thinking of getting a female to male attachment and putting it over the broken part.
Let me know what you guys think I should do if you have any ideas.
Any help will be greatly appreciated, thanks!
(Pic below)

WarMachine · Jul 24, 2016

I personally would do what you are saying, getting a attachment, female to male. With the actual piece that is broken though, I would take a nail file and gently file it down to make it all even. After that, with fine sandpaper (1000 grit) I would go around it to make it nice and dull. That is what I did to my piece when that happened and it's still going strong nearly 2 years in. Def savable!

Ca$hMonay · Jul 25, 2016

WarMachine said:
I personally would do what you are saying, getting a attachment, female to male. With the actual piece that is broken though, I would take a nail file and gently file it down to make it all even. After that, with fine sandpaper (1000 grit) I would go around it to make it nice and dull. That is what I did to my piece when that happened and it's still going strong nearly 2 years in. Def savable!

I'll do that, thanks!

MA MED Grower · Jul 25, 2016

I would say just about any glass blower could fix that brokn joint

Fadedawg · Jul 26, 2016

MA MED Grower said:
I would say just about any glass blower could fix that brokn joint

What MM said.

Ca$hMonay · Jul 27, 2016

Thanks for the help everyone! Successfully fixed

Dab Rig chipped! Is it fixable?

Ca$hMonay

New Member

Attachments

WarMachine

Well-Known Member

Ca$hMonay

New Member

MA MED Grower

Well-Known Member

Fadedawg

Well-Known Member

Ca$hMonay

New Member

Similar threads