Finally brough the CO2 analyzer home (fluke 975 airmeter)...measured CO2 boost that has been running for about a month...with the end of the hose right up to the meter I got a maximum reading of 1250 ppm CO2...left the machine in for grow room for awhile sitting near bottom of plant about a foot and a 1/2 from end of tube that is stuck in top of plant-measure only about 670 ppm CO2, which is about what is in my house...I figure to get good results from this bucket setup you have to have any odor control exhaust fan turned off when bucket/pump is running, and have the hose directly on the plant...I don't think it really will build-up CO2 in the whole room but I will try it out tomorrow. It is tough for me to leave exhaust fan off as too much heat accumulates in room. Conclusion, my first grow...plant produced well for bagseed...not really sure if CO2 boost really helped that much, and don't know if I would buy again for $150. I am going to keep using it up until 3 months is up for vegging plants then move to flowering room again.