advise needed.

ADVICE****

so i wanted to make a grow room made from two tents one smaller then the other. bigger one for flowering smaller for vegging now i wanted it so i get fresh air from outside going into the 1s tent then through an air called hood to the second tent (vegg tent) then exhausted outside the reason i wanted todo this is because i dont want 4 holes in my shed and only want to use one inline fan and one exhaust fan. will i have any problems with this set up?

QUICK RUN DOWN.

Lighting: FLOWER. 1x 250 watt hps air cooled hood. VEGG. 4x 23 watt 6500k cfl 1x 40 watt 2700k cfl

Ventilation: EXHAUST. 1x 6'' inline fan. AIR COOLED HOOD. 1x 6'' 23 watt exhaust fan. CIRCULATING. 1X roatating flat fan 1x small circulating fan.

OTHER: !x carbon filter. 1x fan controller.

this is what i want it to look like.



the second tent is on a table to try make the ducting to have less curves


how can i improve this or what could may go wrong. should i go ahead and buy everything?

You should put the stronger fan and carbon filter connected to the flower tent, scrubbing the air before it gets to the veg. tent. This will also cool you light more efficiently.

one of the seasons i wanted to put the carbon filter in the veg tent is to save room. although i could scrog or something

ditch using a table unless its a workbench type ? if for eney reason that table goes over it would drag over the bigger tent! make a base you know wont callapse .

un named said:

although i could scrog or something

Click to expand...

Yes. scrog!

ill be making the table so ill make it strong enough..i hope lol. being a amateur how would i go scroging it though.