Recent content by watercooled@

I see one on ebay, any thoughts on buying a used machine?

I still roam here on RIU. Good luck on this op, I'll be lurking.

WoW, that sucks. I hope you've got your system running. I know my name might throw you off, but I have nothing to do with any of the companies / parties involved.

fdd, I remember Feb/March you were sitting on some stock. Did you get rid of your 20+ lbs? Dispensary or street? I too will be looking to be a new vendor soon. Fortunately I'm pretty close to LA and will walk door to door if I have to.

OK... here is my opinion. I am not a filter designer, but here it goes. All the real phresh filters use RC-48 activated carbon... (I assume the same as medi's GP filters) This carbon should be relatively tightly packed so that the air is forced to touch some carbon at some point during its...

Just to keep things straight, there is no need to drain the rez on the UC. If needed the epicenter has a drain with a hose fitting, a pump is not needed, but can be used if you wanted to drain very quickly. Seems like you will be going with buckets since you've mentioned your budget on several...

http://www.pexsupply.com/Honeywell-T410A1013-Premier-White-Electric-Heat-Thermostat-Electric-Baseboard-Heat-10491000-p Wire this thermostat into one of the wires of your lights trigger cable and you have high temp shut off for $10. Enjoy!

From the horses mouth... The only trailer(s) I'm involved with are legal medical grows. The primary reason for the trailer is to minimize cost of moving locations until a permanent location is found. The set of trailers may be moved to another state in the future as well. I've been uber busy...

Thanks! I'll look into them. I was thinking filling the gallons of PH up/down, with 50% solution and 50% water to slow down possible over dosing.

Why dosing pumps instead of regular vacuum pumps? Thanks for the info!

I'll comment that the pheno of the Frisian Dew in this grow sucked ass. Very little resin and wasn't dense enough. I probably could have let it sit on the tree for another week or two, but it didn't look like it would get any denser. The buds looked good on the tree (minus the resin) but it's...

Well, I think I'll try hydro finally. My concern was always the PH fluctuations. Even after searching many different forums, I could not find a solution I was happy with. I figured I would be stuck with 3k in costs just for a good PH controller...

Thank you all... I used Advanced Nutrients Sensi A&B for this one @ 50% medium strength.

Nice thread! Looks like you saved a potentially bad situation. How was Blue Sky? I will be flying into Oakland within the next 10 days specifically to pick up some clones there and visit harbor side. Did you have to get there super early, and did they have good pickings for clones?

^ Tried looking for the post you are talking about and didn't find it. Post a link to your plants and my comment so I can follow up and give you my opinion. :-) Happy Growing!