800-1000 is where i thought I should shoot for. And led gardener?'s video was showing 6 hundred something ?dead center 24" above.. I could be remembering wrong. And of course those numbers would go up when multiple boards are used. All speculation for me right this moment
So would it run fine with say 3 maybe even 4 288 boards on the 1050? But each board will be running fewer watts?
Also the 2100 ma will run hotter than the 1050 correct?
Sorry im just trying to make sure im following correctly.
Im not well versed at reading these but those 4k's look good to me.. similar blue as the 5k but w similar reds as the 3k. I purchased 3k and im sure they will be great
I would like to wire 4 288 boards together in series. Im eyeballing the 135 watt kits but would like to limit the number of drivers/plugs. Do you stock a driver that can power all 4 in series that can be wired up for 120v plug? Or am i better off buying the boards /heatsinks from you and...
I had ass-u-med the 260 kit was pretty much just 2 135 kits but only 1 plug/driver. Would there be a way to daisy chain a few of the 135's together to reduce the number of things to plug in?
Thank you for your time and attention!
Sold!
Would it be wiser for me to wait for the slate 3's in may? and just add the slate 3's to the 260w kits for an extra fee? Or shall i get a kit or 2 to play with and just upgrade to slate 3's at a later date. I would hate to wait and then miss out and have to wait again for restock.
This...