Recent content by junglejim3

  1. J

    cloner system using ultrasonic mister

    I built one of these to the exact specs, and lost all of two batches of clones. The first batch I had to fix the mister to the center of the bucket; solved that but the next batch died also; and never developed any roots. I since have returned to cloning in soil; but my new secret is Foliar...
  2. J

    EBB/Flow: Does water cycle change during FLowering?

    It depends on your setup. But a few basic principles you must grasp; 1-Don't water at Night..Plants don't need it! 2- Everyone's setup is a little different; I'm growing on a flood table with 4 inch rockwool blocks; I water drip and flood 5 mins 3 times a day; once in first hour and 2 hrs...
  3. J

    Super Thrive for Cloning??? ANY tips for cloning?*********+REP+************

    Exactly How do you use it? How much and when? and is that all you use?
  4. J

    Let's talk lighting schedules (12/12, 11/13, etc)

    My reading has shown that 12on 12off is the simplest and best . I do believe that veg fluoros are great, and use them with my HID's before flowering. I grow great smoke , probably would not want stronger.
  5. J

    Rockwool in Soil Watering Question

    Yes, you have probably over watered; get a scale and weigh them daily keep the weight around 45 grams and they'll do fine. Don't transplant until you see roots growing out the bottom. Also read my post on using rockwool cubes.
  6. J

    CLONE PROBLEMS

    They don't look too bad. 82 seems a little warm; adults don't like temps much over 80 water them until they weigh 45-50 grams and weigh daily you should be OK; DON"T Fertilize.
  7. J

    How to use 4" Rockwool cubes-- Important Info!

    I have scouted around and looked everywhere and this information is NOT to be had; too bad, because if you are going to grow in 4" Rockwool cubes you need it. Most instructions tell you to pre soak the cubes for as long as 24 hrs--WRONG. if you do prepare to wait a long time for your plants to...
  8. J

    System Design --Drip plus Ebb and Flow table

    I built a table out of 2x4's to support the tray-buy a commercial growing tray with drainage channels for 30 to 50 bucks. Don't try to build one out of plywood; which was my first idea --You will never get it to hold water and it will cause you endless problems -- just build a square frame and...
  9. J

    Harvest a Pound Every Three Weeks!

    I would like it if you could also list what you use for Flowering Nuts?
  10. J

    pH up powder mixing formula

    I have used GH pH up with good results. I then discovered that the powder was available, at a much cheaper price. However I was unable to discover, anywhere on the Internet, including the GH site how to mix up the solution. Since I was familiar with the liquid product I wanted to know how to...
  11. J

    Please comment on my new system design

    My new system features a 2x4 foot grow table; angled down 1 1/2 inches; clones from 2 " rockwool cubes ....14 on the table Irrigation drip from emitters, cycled for 2 minutes per day; Growing in 4 inch Rockwool Cubes on a coco mat 1/4 inch thick. Using GH nutes. Reservoir is 20 gallons. I ll...
  12. J

    Got my grow room set up, what ya think??

    Good Setup; I wished I'd started with that. Bring in air from room and exhaust to attic you may want to make a charcoal filter if odor is a problem
  13. J

    Is this Design for Ebb and Flow Ok... Will it work?

    I have a designed system that I created by reading lots of posts. Please let me know if you think it will work OK, or let me know the problems it may create. Here is my ebb and flow system: It is a 2x4 table on which I plan to grow 14 plants in 4inch Rockwool cubes sitting on a coco mat. My...
Top