I currently grow regular feminised seeds in a simple DWC setup. I feed using Canna products and following the feeding guide from their site here
If I want to grow an auto-flowering strain how should I feed the plant - is it the same throughout the growing period?
I went for active heating on my small 4x COB grow. I've got to admit some of the heat sinking on the project seem excessive - 56' of 1" heatsink will dissipate A LOT of heat...!
Just had a look on diyled - he's using U channel - so no problem there :)
I can source everything I need in the UK now, or from european warehouses. The only thing I'm having trouble finding is the 1" wide heatsink bar, well, any heatsink bar... :| Any ideas?
Unfortunatly https://www.diyleduk.co.uk is out of stock of virtually everything!
More than happy going DIY if I've got a list of bits (and supplier links of course :clap:) and a circuit diagram - can you help me with that? :bigjoint:
Got him to revise his grow size... It's off to the side of one large tent, as he needs to "work" in it too. He reckons the size is about 100cm x 180cm.
He wants to go to LED mainly from a heat point of view - 1200w of HT lights kick off some heat.
Considering a kit like this...
Friend is currently running a grow 140cm x 60cm using two 600w sodium bulbs.
He wants to swap to LED to save money.
I run a smal grow (60cm x 60cm) with 4 cbx3590 cree LED's so a solution similar to them would be great - these were source from Cutter AU.
I'm in the UK but will happily...
Friend is currently running a grow 140cm x 60cm using two 600w sodium bulbs.
He wants to swap to LED to save money.
I run a smal grow (60cm x 60cm) with 4 cbx3590 cree LED's so a solution similar to them would be great - these were source from Cutter AU.
I'm in the UK but will happily...
Hope I've posted in the right forum - I could of swan there was a dedicated thread for Canna but couldn't find it...
cI've been using the Canna Coca grow guide to feed my plants and have a query over final week/flushing?
The final week of the grow guide cuts all feed/nutrients apart from...
Attached is a zip file containing "plus" and "minus" parts - find a local 3D printing hub and get them printed locally...
You can also find them on Thingaverse - https://www.thingiverse.com/thing:2849964 - this will also allow you to access 3D printing hubs directly too...