Portable Grow Room

KushMaster85

KushMaster85

Well-Known Member
Building a portable grow hut
Materials required:
1" (Schedule 40) PVC (60 ft)
1" 3 way 90* elbow (8)
1" 4 way 90* elbow (8)
Black/White Poly (10 X 100)
Duct Tape
Iron on Zipper
Step 1. Cut PVC to lengths required.
(16) 30" long
(04) 48" long
(08) 12" long
Step 2. Assemble PVC and Elbows
Step 3. Wrap the frame that you just built with the poly using
duct tape to secure it in place. Iron the zipper to the front poly.
Now you have a portable grow room that only requires one person
to move. If you dont use glue to secure the joints on the PVC then
you can easily break it down when it is not in use.
The material will vary depending on design. This is for a 30"D X 30"W
X 72"H. This design also calls for horizontal braces place 12" from the
top and bottom of the box on all 4 sides.

 
T

Tenley

Active Member
hey kush,
I built basically the same thing. 2.5' X 2.5' X 7'. Its hidden in a bathroom shower. I regret using wood though. PVC wasn't cheap and neither were the elbows. Wood is more sturdy although I did use 1/2' PVC and didn't brace it so your frame probably doesn't flex like mine. If I could do it over again I'd use pine wood and screws. It would still be fairly light and portable. Masking tape worked better for me then duct tape too. After a week the duct tape was falling off with ~85F and ~60% humidity.

Do you have any pictures of yours? Did you have slack problems with the zipper at all?
 
You must log in or register to reply here.
Top