Small little room created out of 2x4's
Dimensions: 6x5 ft 7 ft high
Black plastic around the exterior
Mylar covering everything inside except the roof
Two 10x10 inch vents at the bottoms of the room on opposite sides covered by screen
1 oscillating fan in front of one of the vents
1 squirrel cage fan dangling from the center with the intake right near the lamp - ducting leading out of the room via hole in the plastic.
600w MH - ballast is located outside of the growroom
96 degree Fahrenheit
THIS MAY BE A FACTOR.... this temperature was taken as a test run to determine temperature before the plants are actually placed into the environment. As of right now my seeds are still germinating and not quite ready for the growroom...
There is no water in my reservoir and about 30-40 percent humidity...
will temperatures decrease once my reservoir is full?
If not... any suggestions?
Or am i by any chance doing something critically wrong...
I really didnt think that getting a cooled light via air or water involved in the hood was going to be a necessity for me
ALSO... can i make more 10x10 inch vents on the tops of the room to let out more heat?
Thanks so much in advance... looking forward to the insightful replies!
Dimensions: 6x5 ft 7 ft high
Black plastic around the exterior
Mylar covering everything inside except the roof
Two 10x10 inch vents at the bottoms of the room on opposite sides covered by screen
1 oscillating fan in front of one of the vents
1 squirrel cage fan dangling from the center with the intake right near the lamp - ducting leading out of the room via hole in the plastic.
600w MH - ballast is located outside of the growroom
96 degree Fahrenheit
THIS MAY BE A FACTOR.... this temperature was taken as a test run to determine temperature before the plants are actually placed into the environment. As of right now my seeds are still germinating and not quite ready for the growroom...
There is no water in my reservoir and about 30-40 percent humidity...
will temperatures decrease once my reservoir is full?
If not... any suggestions?
Or am i by any chance doing something critically wrong...
I really didnt think that getting a cooled light via air or water involved in the hood was going to be a necessity for me
ALSO... can i make more 10x10 inch vents on the tops of the room to let out more heat?
Thanks so much in advance... looking forward to the insightful replies!