theMONSTER
Well-Known Member
i will start out as saying that i plan to grow big this year, dont we all? and i would like some help on my design, how to make it better, make it work and how to keep the noise and all that shit down and low profile. this box is only for sprouting, although i may keep one or 2 in the box until it outgrows the box.
so im going to build/already building a small grow cab. now its only to sprout around 50 seedlings, get them about 6or 7 inches. then transplant them into the woods.
i am using some seeds from the ragady ass weed you can buy where i live. but i think if i grow hem, keep the best looking males, and get seeds, and then keep doing that mayb i can make my own strain. however i would have no way of knowing any genetics so as far as that goes im not to sure.
The cab is about 3 ft tall, 3 ft wide, and about a foot and a half deep. so basically square shaped and 1 1/2 ft deep. all i have done, is painted the outside, and sealed all visible cracks on the inside with caulking. For light i have 4- 2foot flouros.
for ventilation i will cut a hole in the side with a jig saw, put up a 120 micron screen and the outtake will just have a screen by the hole, they will both be on the back of the cab.
right now it is a bare box, no cuts or holes drilled in it yet. just hinges and a door ......
so im going to build/already building a small grow cab. now its only to sprout around 50 seedlings, get them about 6or 7 inches. then transplant them into the woods.
i am using some seeds from the ragady ass weed you can buy where i live. but i think if i grow hem, keep the best looking males, and get seeds, and then keep doing that mayb i can make my own strain. however i would have no way of knowing any genetics so as far as that goes im not to sure.
The cab is about 3 ft tall, 3 ft wide, and about a foot and a half deep. so basically square shaped and 1 1/2 ft deep. all i have done, is painted the outside, and sealed all visible cracks on the inside with caulking. For light i have 4- 2foot flouros.
for ventilation i will cut a hole in the side with a jig saw, put up a 120 micron screen and the outtake will just have a screen by the hole, they will both be on the back of the cab.
right now it is a bare box, no cuts or holes drilled in it yet. just hinges and a door ......