Query, driver apv 12-12 on 4 pin fan

hello bros, I have not been able to make these fans work, I do not know if something is doing wrong or connecting badly, I counted the black with the red according to the scheme but still I can not get it to work.
I'll be forgetting something?

How much current do the fans draw? Should say on the front.
APV12-12 has 1amp of current it can split amongst your 12v fans. I have some that are 0.15a that I could run 6 maybe even 7 on and I have others that are 0.5a which would only let me run 2.

Airwalker16 said:

How much current do the fans draw? Should say on the front.
APV12-12 has 1amp of current it can split amongst your 12v fans. I have some that are 0.15a that I could run 6 maybe even 7 on and I have others that are 0.5a which would only let me run 2.

Click to expand...

Thx , I'll try two as I'm going, here's the technical data


Electrical Characteristics
Typical Voltage:
12V DC
Current:
0.11A
Start-up Voltage:
6.0V DC (@ 100% PWM)
Cable Length:
400 mm

linderstein said:

Thx , I'll try two as I'm going, here's the technical data


Electrical Characteristics
Typical Voltage:
12V DC
Current:
0.11A
Start-up Voltage:
6.0V DC (@ 100% PWM)
Cable Length:
400 mm

Click to expand...

You can run 8-9 of those fans on the APv 12-12

Airwalker16 said:

You can run 8-9 of those fans on the APv 12-12

Click to expand...

then the driver does not work for 1 single, I'll try 2 or 4 as I go ....

linderstein said:

then the driver does not work for 1 single, I'll try 2 or 4 as I go ....

Click to expand...

Hook up black to black and red to red. The other 2 pins are for signal. Not needed

linderstein said:

then the driver does not work for 1 single, I'll try 2 or 4 as I go ....

Click to expand...

You need To put them all on. Hopefully that Single fan isn't fried.

Airwalker16 said:

You need To put them all on. Hopefully that Single fan isn't fried.

Click to expand...

if I expected not to be burned, I was thinking of using a source of adjustable power (rs-15-12) again I have a doubt if I connect 2 for example would be approximately 0.22A, with this new source would it be necessary to regulate it so that they consume the necessary or simply consume the necessary?