maineyankee
Active Member
Thanks so very much for stopping by. I am in the middle of constructing a DIY Cloner. The tote capacity is 19 Gallons, and I used 3/4 inch PVC Pipe, along with 360 Degrees E-Z Cloner Nozzles. The pump is an Argo-Max that is 250 gph. I had to "Tweak" and use a barbed "Tee" attachment, since my local Home TeaPot did not have on hand a straight 3/8 to 3/8 inch barbed piece that would go from the tubing to the PVC Pipe.
I, at very best, am getting just a dribble from all 10 sites that the Cloner Spray is attached to. There are no leaks around them, as I took my time and used the proper drill bit, screw, etc to make sure that this would not be an area to loose pressure. The small jar that I used as a "Tweak", shows no sign of leakage as well. The reason for my doing this aspect, was to allow water to fill the container, and then the pressure would be built there, and then distributed throughout the actual PVC Pipes.
I checked the water pump, and the impeller is not clogged or jammed. Outside of my getting the 3/8 barbed attachment, is there any reason why I am only getting a dribble? I figured at 250 GPH, this thing should be shooting like there is no tomorrow. I have attached several pics to help solve this mystery.
Again, thanks in advance
MaineYankee
I, at very best, am getting just a dribble from all 10 sites that the Cloner Spray is attached to. There are no leaks around them, as I took my time and used the proper drill bit, screw, etc to make sure that this would not be an area to loose pressure. The small jar that I used as a "Tweak", shows no sign of leakage as well. The reason for my doing this aspect, was to allow water to fill the container, and then the pressure would be built there, and then distributed throughout the actual PVC Pipes.
I checked the water pump, and the impeller is not clogged or jammed. Outside of my getting the 3/8 barbed attachment, is there any reason why I am only getting a dribble? I figured at 250 GPH, this thing should be shooting like there is no tomorrow. I have attached several pics to help solve this mystery.
Again, thanks in advance
MaineYankee