Light Leaking out of Stealth Cabinet. Question on how to seal

Discussion in 'General Marijuana Growing' started by sow217, May 16, 2009.

  1.  
    sow217

    sow217 Well-Known Member

    Hi all,

    I purchased the cabinet below and have it set up without the partion in the middle and only with the top shelf for seedlings and clones. The bottom section is used for a Vegging Chamber. Everything is set up and all is well, except for one problem. I have light leaking out of my cabinet where the cracks are by the hinges and also where the doors meet in the front. I need to somehow seal these as it completely eliminates my purpose of the cabinet being stealth. Any advice on how to make this completely light proof and sealed is greatly appreciated. Thanks
    [​IMG]
  2.  
    Mindset83

    Mindset83 Active Member

    Buy some black fabric from a Walmart or craft store. It's only $1.50 per yard and will block all the light. just staple it to the top of the dresser and drape it over the front of the cabinet with the doors open. When the doors shut the fabric will block all the light from any opening. Just make sure to get a fabric that light can not penetrate.
  3.  
    demonic1

    demonic1 Well-Known Member

    Staple Panda Film (that white and black plastic sheet stuff) all along the top and along the sides of the inside of your cabinet like a curtain to block any light leakage. Make sure you overlap at the door about 3 inches and you should be good.

Share This Page