I thought I'd pretend I didn't understand this thread.

[AltarNation]

But I do.

 

[Growan]

Don't geddit

 

[ChingOwn]

Me needer

 

[Growan]

Only kidding. I geddit

 

[CC Dobbs]

As I was saying, If the left side hangs lower than the right you'll need a shim or maybe a couple of well placed staples. If that works then go back to the beginning and start over. And do it right this time.

 

[AltarNation]

If the caliper is properly calibrated, the caterpillar's capillaries could be cauterized.

 

[ChingOwn]

my balls itch

 

[Growan]

Use a spring ballance to measure backload, then grease the back of the new pads before dusting with icing sugar

 

[CC Dobbs]

Use a spring ballance to measure backload, then grease the back of the new pads before dusting with icing sugar

That sounds like good advice but I measure the balance and then spring the backload. As long as the Oppenheimer bolt is finger tight then it is a go.

 

[Growan]

That sounds like good advice but I measure the balance and then spring the backload. As long as the Oppenheimer bolt is finger tight then it is a go.

If there's excessive play in the crow's nest it might be worth checking you re-fitted the bleed nipple rubber cover before overiding the snorbits. I mean, safety first, right?

 

[MightyMike530]

Ive read it three times, dont know what this is all about....

 

[GreatwhiteNorth]

I was under the impression that unless you cracked the Finster valve slightly before you dipped it in the Relative bearing grease then there would be much less drag on the Pitot tube.

Or am I thinking of an easy-bake oven ?

 

[polo the don]

I have an extra Flux Capacitor if you need it. That would solve all these problems.

PayPal accepted.

 

[bu$hleaguer]

I think that's the same guy who hit that old woman with his car.

 

[AltarNation]

No, no... marsupials, they have a groin stitch. It's like a coin purse for your stethoscope--an off-color ethical coping mechanism. It travels several times faster through time than it does through space. The motives are endless. Leave the calibrations to the professionals.

 

[ASMALLVOICE]

I have no idea what the hell is going on.

I'm not good, but I'm slow.

Peace

Asmallvoice

 

[CC Dobbs]

If there's excessive play in the crow's nest it might be worth checking you re-fitted the bleed nipple rubber cover before overiding the snorbits. I mean, safety first, right?

Safety is always job #1 unless your in a hurry to go in which case I will set the centrifuge to '0' and hope for the best. If my nipple is bleeding I will cover it with rubber too.

 

[CC Dobbs]

I was under the impression that unless you cracked the Finster valve slightly before you dipped it in the Relative bearing grease then there would be much less drag on the Pitot tube.

Or am I thinking of an easy-bake oven ?

You are thinking of the Easy Bake Oven but only the pre-1973 ones had a Finster valve. I have a 1975 EBO and I use it every day to make delicious iced cupcakes.

 

[Growan]

Try o instead of 0. It's a little less pointy, and therefore saferer.

 

[CC Dobbs]

I have an extra Flux Capacitor if you need it. That would solve all these problems.

PayPal accepted.

Dude!!!! I've been looking for one on Craigslist for years. My brother wants one too.