Weedler
Well-Known Member
Just put together my 3'x3'x6' tent. Took like 10 minutes real nice design and highly reflective material.
I have two four 5GA buckets (light proof) with 5" pot lids. Started AK48 & White Widow feminized from seed about 2 weeks ago. They started off under a T5 light and I just moved them from the closet to the tent and under the 250W MH / HPS
190 CFM exhaust fan 4"
110 CFM 4.5" Axial Fan (intake)
(3) 6" fans for air movement in tent all set on low right now (2 speed)
Carbon Filter (will be added when needed)
Black Air tubing
My water here is 200 PPM and 7.8 PH
I drilled a 1/4" hole in the side of the bucket near the top so I could remove the lids without having to deal with air hose & stone.
Marked the 3GA line on each of the 4 buckets. I'm only using two buckets this round, so I am able to let water stand for a day with air being pumped into it to reduce chlorine.
I mix General Hydroponics Hardwater Micro & Bloom 7.5ML for 3GA in each bucket right now they seem to be taking it good and I plan on increasing it slightly tomorrow.
Here's some photos enjoy
White Widow Macro shot she was planted 2 days earlier than AK48, her roots were the last to exit the 5" pot. She looks to be catching up now.
AK48 Macro shot
Air entrance duct taped down 4-5" to prevent any light leak.
Shot of fan and wire exit. Also exhaust exit.
Carbon filter ready to go when needed
190 CFM Exhaust fan read for carbon filter when needed
Buckets 84.7 and slowly going down trying to get temp just right
Fan controller
Nutrients / PH Down/ Rockwool Conditioner / GH HW Micro / Bloom & Sweet Necatar I think
AK 48 Macro shot
3x3x6 Tent
110 CFM 4.5" Axial Fan I made a square box fit into a round hole
I have two four 5GA buckets (light proof) with 5" pot lids. Started AK48 & White Widow feminized from seed about 2 weeks ago. They started off under a T5 light and I just moved them from the closet to the tent and under the 250W MH / HPS
190 CFM exhaust fan 4"
110 CFM 4.5" Axial Fan (intake)
(3) 6" fans for air movement in tent all set on low right now (2 speed)
Carbon Filter (will be added when needed)
Black Air tubing
My water here is 200 PPM and 7.8 PH
I drilled a 1/4" hole in the side of the bucket near the top so I could remove the lids without having to deal with air hose & stone.
Marked the 3GA line on each of the 4 buckets. I'm only using two buckets this round, so I am able to let water stand for a day with air being pumped into it to reduce chlorine.
I mix General Hydroponics Hardwater Micro & Bloom 7.5ML for 3GA in each bucket right now they seem to be taking it good and I plan on increasing it slightly tomorrow.
Here's some photos enjoy
White Widow Macro shot she was planted 2 days earlier than AK48, her roots were the last to exit the 5" pot. She looks to be catching up now.
AK48 Macro shot
Air entrance duct taped down 4-5" to prevent any light leak.
Shot of fan and wire exit. Also exhaust exit.
Carbon filter ready to go when needed
190 CFM Exhaust fan read for carbon filter when needed
Buckets 84.7 and slowly going down trying to get temp just right
Fan controller
Nutrients / PH Down/ Rockwool Conditioner / GH HW Micro / Bloom & Sweet Necatar I think
AK 48 Macro shot
3x3x6 Tent
110 CFM 4.5" Axial Fan I made a square box fit into a round hole
