Cloning in a grow tent?

Anyone have any ideas how to divide a GL60 or 80 so that I can clone in one side on a 12/12 and have females growing on the other on a 24/0?

i used to have my tent split down the middle with two 250w light setups i did it with two sheets of black plastic about 4 inches to long and to wide hung them together and like the letter "I" where it met the wall iused duct tape a hole near top for duct work bottm vent open

i later covered black plastic with reflective material

ran fine sativas on one side indacas on other i had to break it down tape was a nightmare now i just use both lights at same time in one tent no seperations now i have a little closet etuo next to tent i use for startups i dont do clowns and moms but i do use it for autos diesel ryders got 2 in there now

good luck 1 love

Thanks I am just going to grow in 2 tents instead, sounds easier