CLONE PROBLEMS

Hello everyone lately I have been having problems with my clones can't get to see to them them right. I have growing 5+ years so I know what I'm doing maybe I'm not seeing something
Clones cut and put in cup with tap water (my tap comes out 50ppm ) for 24hrs at that time rockwool cubes are pre soaked for 24hrs also in 5.5ph (also tried for 10min to see if that was an issue) than cubes are salad spins until they weight about 25/30grs just damp. Cutting are given a 45° cut shaved skittle off the sides than dipped into rooting IbA powder and plugged into cubes.
I give a dark period than place in a controlled environment 82F with 60% RH no wilting from roots just fucked up looking leaving what can it be thanks

They don't look too bad. 82 seems a little warm; adults don't like temps much over 80
water them until they weigh 45-50 grams and weigh daily you should be OK;
DON"T Fertilize.

They look fine to me, what problem are you having?

Don't cut your leaves.

Dude your method is wrong but dr pecker is lost. Don't listen to him. FFS whats wrong with this forum. Ok, so basically when you take your cutting, youll want to drop it in the water, but pull out shortly after into cloning compound, into pre soaked rock wool. This soaking stuff is useless. Just KISS.

I cut, place in ater for 5 secs, then cut again at 45 degree, into cloning solution, then into my pre socked cube, and into the dome. I have 98 % success

I recently switched to a homemade bubble cloner, 100% success so far. I made mine for 2 dollars. Never going back to domes and misting.

dont soak the clones that long. a few minutes at most it helps if you lightly scratch the stem whare the root hormone is going to be and cut on a 45 degree angle

pickpocket33 said:

Dude your method is wrong but dr pecker is lost. Don't listen to him. FFS whats wrong with this forum. Ok, so basically when you take your cutting, youll want to drop it in the water, but pull out shortly after into cloning compound, into pre soaked rock wool. This soaking stuff is useless. Just KISS.

Click to expand...

what are you talking about?

"don't cut the leaves" Please don't give bad advice.

How is cutting leaves on a clone good?

please enlighten me ill be back later got my own to tend to but I have to see this later.

www.growweedeasy.com www.google.com www.rollitup.com www.imnotyourmother.com

Marijuana horticulture - The indoor/outdoor Growers bible also.. to name a fucking few.. .

malicifice said:

I recently switched to a homemade bubble cloner, 100% success so far. I made mine for 2 dollars. Never going back to domes and misting.

Click to expand...

This and its fun ...did I say fun and with high very high results

Not trying to jack your thread. I was just like you 7 days ago.

do you peal the root riot off when your done?

the only time I ever have a problem cloning its strain specific and I never cut any leaves I even make sure I have at lest one leaf node (after beeing trimmed a little) covered with hormone.

my g13 will clone in a glass of water

Dr.Pecker said:

do you peal the root riot off when your done?

Click to expand...

Yeah I didn't have any pucks on hand so I just cut the rooter down one side like a puck.