George2324
Well-Known Member
I’m looking for some recommendations on how to design the lights for my mother/clone room.
I plan to keep the clones in this room from cut to 5 weeks.
The head room is extremely small. I will put the stem lower and lower into the cloner if I need to as it grows. With that said though I don’t think I’ll have too many issues with height. There is enough room for a 7 inch main stem before I have to lower it
With this in mind I’m looking for a low profile design. Possibly with nothing more than thin aluminium sheeting?
Looked into quantum boards but nobody selling them where I am from.
As it’s only a clone/mother room I don’t need anything too powerful. I just need enough for tight nodes as they go straight to flower after they leave this room.
I already have cobs in the flower room and my old veg room been a while since I had to work out numbers and can’t get my head around these striplights from Samsung etc
Cheers
I plan to keep the clones in this room from cut to 5 weeks.
The head room is extremely small. I will put the stem lower and lower into the cloner if I need to as it grows. With that said though I don’t think I’ll have too many issues with height. There is enough room for a 7 inch main stem before I have to lower it
With this in mind I’m looking for a low profile design. Possibly with nothing more than thin aluminium sheeting?
Looked into quantum boards but nobody selling them where I am from.
As it’s only a clone/mother room I don’t need anything too powerful. I just need enough for tight nodes as they go straight to flower after they leave this room.
I already have cobs in the flower room and my old veg room been a while since I had to work out numbers and can’t get my head around these striplights from Samsung etc
Cheers