Oh yeah, the inside is fine except for the back ...Once you rip/bend plastic, it looks like shit....& the copper wire/freon pipe & heating element?, would just not cut...I bought the hole saw; what a rip off...Would barely cut through the damn thing...So i took a hammer and started beating the fuck out of what hole it actually did cut through....somehow, I ended up with two holes just a bit smaller than the fan (which it circulates all too well
The fan's are 1.4 amps per each, and I'm wondering how many watts that will consume on 220v? They plug straight into the wall...Any idea how much my utility bill will spike with these fans? I've replaced all the lights in the house (started anyways) with CFL. Also, the fans always run typically (house fans; a/c cracks my allergies up), so I'm wondering if I'll notice much of an increase with this setup. 2 fans (1.4 each) 4 65w cfl (consuming 11 each for these) & a 32 watter circular (which, btw, is the best damn light I've ever bought I think. It's soooo bright, and hits EVERY part...No light leaks except for a small amount out the back & I'm going to duct tape it off anyways...it's just around the fan...The fans are stuffed in, rather than drilled in (didn't come with screws; go figure), but it's a tight fit & I figure with duct tape around it, will seal light and extra support....sound good? great
what week you in now?