DarthBlazeAnthony
Well-Known Member
I just made 100 cannacaps using the following steps. I used about an ounce of ground up chronic to fill 100 caps. If you wanna give it a go just follow the steps here.
You will need an ez-cap-filler, 00 size caps, cannabis, coffee grinder, vacuum sealer, vacuum seal bags, thermometer, pot, a wrench, and a stove.
1. Grow some good cannabis.
2. Cure and dry properly
3. Remove any sticks and stems.
4. Put bud into a coffee grinder and grind it up.
5. Put a piece of metal in the bottom of the bag and seal. I use a wrench to add weight. This will add weight to the bag so it wont float to the top whilst boiling the vacuum sealed bag.
6. Add grinded bud into the bag and vacuum seal.
7. Turn on stove to slightly above medium heat.
8. Measure temperature with a thermometer and adjust temperature to 200 degrees Fahrenheit.
9. Place vacuum sealed herb into pot of water for 1 hour and 40 mins. This will completely decarboxylate the cannabis.
10. Remove bag from water and cut the vaccum seal.
11. Empty decarbed cannabis on to a clean plate.
12. Add the end caps into your ez-cap-filler.
13. Place grinded, decarbed weed on top and use the tamper to fit as much into each pill as possible.
14. Add top caps to all filled bottom caps.
15. Enjoy
#Canna-caps #Cannacaps
You will need an ez-cap-filler, 00 size caps, cannabis, coffee grinder, vacuum sealer, vacuum seal bags, thermometer, pot, a wrench, and a stove.
1. Grow some good cannabis.
2. Cure and dry properly
3. Remove any sticks and stems.
4. Put bud into a coffee grinder and grind it up.
5. Put a piece of metal in the bottom of the bag and seal. I use a wrench to add weight. This will add weight to the bag so it wont float to the top whilst boiling the vacuum sealed bag.
6. Add grinded bud into the bag and vacuum seal.
7. Turn on stove to slightly above medium heat.
8. Measure temperature with a thermometer and adjust temperature to 200 degrees Fahrenheit.
9. Place vacuum sealed herb into pot of water for 1 hour and 40 mins. This will completely decarboxylate the cannabis.
10. Remove bag from water and cut the vaccum seal.
11. Empty decarbed cannabis on to a clean plate.
12. Add the end caps into your ez-cap-filler.
13. Place grinded, decarbed weed on top and use the tamper to fit as much into each pill as possible.
14. Add top caps to all filled bottom caps.
15. Enjoy
#Canna-caps #Cannacaps
