JavaCo
Well-Known Member
You should call Fluence a Osram company and tell them they dont know what they are talking about.
655W in 3x3 or 4x4?
- Thread starter ismann
- Start date
Major Blazer
Well-Known Member
whytewidow
Well-Known Member
You need higher temps. I run 84-86 @60% humidity. Clear through. Start to chop. If I drop below 77° they get all droopy. Atleast in my experience. But you def need to be above 80° with strips.
Damn those numbers are pretty bad aren't those fixtures like $1400?!
JavaCo
Well-Known Member
I showed how to calculate PPFD from the PPF numbers in my first post. Not going to make a difference the further the light sensor is from the LED the lower the PPF readings then doing the math to calculate PPFD will show it gets weaker the higher the light.
Major Blazer
Well-Known Member
Last edited:
whytewidow
Well-Known Member
Yeah i know.LOL. 32"x32" is 7.111111111111111 square feet.
ppf is the total output of a lamp. ppfd is the total output of the lamp over an area. why is that so hard to understand? ppf can only be measured in an ulbricht's sphere. now go weep in a corner, loser
Airwalker16
Well-Known Member
Yah I was super surprised. Too