Recent content by king.kush420

FYI, Massachusetts just legalized marijuana for medical use. The limit on how many growers in the state was set at 35. the business licenses are are awarded like contracts.

your first step, (other than to read the rules of the site, i.e. no talk about selling) if you want to provide marijuana to medical patients in your area, is to grow hydroponically indoors. Unless you plan on building a few fancy green houses not hat 10 acres, your crop probably wont even make...

Rapid rooters are the best, good choice. If you were like me my first time, I found out using the dome is pointless. it's gets to hot, and the humidity doesn't even get above 60%. Here's a photo of what i do now. (Mango Kush) I just keep them open under the light. I do not spray my clones at...

Mr Chonicbob, Being from Seattle myself, and a medical marijuana patient, i can tell you that what you want to do, probably wont happen. what I mean is there are already many licensed growers in that area that provide to local dispensaries. and most of them will be called upon to provide to the...

Side not about ventilation. So that I wouldn't damage my rental property, I went to the home depot and bought a replacement bedroom door, (only $18) Cut a couple of 6" holes, and i vent directly from my tent into the hallway. I have a 4x4 tent in a 15x12 room, but if i vent my warm air directly...

If you are using a 1000watt, you're gonna need a way to keep your nutes cool. (if you mean to put the res inside the tent.) When i did DWC in 5 gallon buckets, unless i used a water chiller, my res temp would get up to over 80 degrees. Using the set up in the picture, I'd put the res outside the...

I ask a direct question in the newbie forums about pH level with soil-less media, and all of them say to use 5.8-6.0

I usually crop atleast twice, depending on how many branches there are. What I aim for is to get atleast 6-9 GOOD tops per plant. Your pic that shows both,The shorter one. if that was my plant, I'd crop those, what looks like 3 maybe 4 tops and then veg until that new tops get atleast 4-6...

Cool, thx for the info guys. My local hydro store has sunshine mix #1&#4. I was thinking about using one of them. I've her of people using Mix #4 before, I'm gonna be using an Advanced Nutrient line up as well.

I've been thinking about doing some soil-less media. I was wondering, When I make up my nutes, do I need the pH level for soil, or 5.8 like in typical hydroponics? One other question, would it be better to get a soil-less mix with a wetting agent or one without?

First grows are the best, On my third right now. Remember, don't forget, after harvest it will still need about a week to dry and another week to properly cure your buds. But i got to say, that looks delicious. :hump:

I'm kinda in the same boat with DrFelterpus, I was gonna but some sunshine this weekend. I've only used typical soil. And since peat moss is a soli-less mixure, I'm sure sure whether you would need the higher pH like with soil, or the lower 5.8 like typical hydroponics. I've never actually...

I'm not sure if it was noted, but make sure not to use cold water when watering your plants. you want it about room temp.

When you mist your clones, the leaves get the water directly. what you want to do, is encourage root growth. Don't mist your clone, and you will get roots faster and increase the chances your clone will survive. The clones become weaker the longer they take to form a root system. If the clone is...

Here's what I do. I cut, then carefully skinaway the outer layer all around the entire stem between the bottom two node i plan to place under the surface, or atleast 1/2 inch long, then i cut the stem down the center to pretty much make it a fork. then i dip in the clonex and put them in rapid...