What LED driver do i need?

I purchased a 50w ufo (25 x 3w) and after a couple of hours it stopped working. I believe the power supply for the leds has blown. The company is sending out new light so i was going to repair the other one. I have been trying to find a driver to suit. This is a pic of the driver specs that was in the light



I have seen heaps of 50w led drivers for sale but they have an output current of 1500mA. I'm not to sure about mA and stuff like that so i was wondering if a driver with an output of 1500mA is way too much or can it be used. If anyone can help or has a link to a driver that would suit it would be appreciated.

I'm no expert, but you certainly need to get close on the amperage. I'm sure 600ma would be ok and 650ma would probably be ok. I did a bit of looking from people I have purchased from and i didn't find one that was 50W+ @ 600ma or 650ma but I'm sure they are available somewhere. If i run across one I'll post if no one else has answered.

You could always break it out to two sets of 12-13 and use two drivers. 1 track cut, 4 wires.