venting 600 watter

N

n8thegr8

Active Member

• Sep 6, 2008

• #1

question trying a new grow space. i have a 600 watt hps light with a cool tube. i hope to run my venting like this will it be good enough. i am going with a 6 inch carbon scubber to a 6 inch fan booster through my cool tube to a 6 inch can fan 400 cfm out of the room. will this be enouigh to cool the room 3 x 3 x 8.5 also do you think i will have smell issues with the carbon to the cool tube. Thank you peace

 

mane2008

Well-Known Member

• Sep 6, 2008

• #2

yes it'll work.
do you already have the canfan?

 

desertrat

Well-Known Member

• Sep 6, 2008

• #3

you probably don;t need the booster fan but you will need venting for the room itself, both to bring in fresh co2 and to cool the room itself

 

N

n8thegr8

Active Member

• Sep 6, 2008

• #4

yes actuall it is a grow bright my bad but it is the same design just a little less money. sorry just never had so much light in such a small space. also do you think 6 inch carbon enough or should i get the 8 inch carbon can

peace

 

N

n8thegr8

Active Member

• Sep 6, 2008

• #5

yea i am hoping that i will create enough negative pressure to allow co2\air in through a passive vent hole. no co2 enrichment yet so venting my co2 is not too much of a worry. Working on a much smaller scale then i am used to

 

mane2008

Well-Known Member

• Sep 6, 2008

• #6

yea wat des said you dont need two fans for exhaust.
use the booster for intake.
6in should be enough.

 

N

n8thegr8

Active Member

• Sep 6, 2008

• #7

cool i am just worried about cooking the pants with too hot a light

 

mane2008

Well-Known Member

• Sep 6, 2008

• #8

you good i had a vortex pulled 447cfm did the job.