Question on Nozzles & Tee Connections

I've been using a LP system for years and decided to build a HP to try this year. Looking at all the available nozzles it has become overwhelming. I'm trying to keep the budget down since the accumulator tank will cost me a pretty penny. What does everyone think about the these Tefen Plastic Fog Nozzles with Poly Filter Misting in Poultry White with 1/8 inch NPT at a rate of 1 GPH? They cost between 14 - 20 USD for a pack of 10 nozzles. If not any suggestions of what to look at around the same price range?

The other question I have is about Tee connections. If I were to but the Tefen Nozzles are their any Tee connections with a 1/4 inch tube quick connect with 2 female threaded ends for these nozzles to screw into? I would like to be able to run 2 nozzles to every Tee connection. Can it be done?

They make FPT to push fit adapters, I get mine on Amazon. You could do a push fit Tee and then two of those adapters from there.

You should tell us about your chamber and proposed nozzle layout, and I'm guessing Atomizer may chime in with some admittedly cryptic advice that could simplify your design so that you don't even need the complexity of what you're asking for.

Cryptic? lol
There`s a couple of options, nickel plated brass 1/8" npt female to 1/4" pushfit, quite pricey as they are typically used for pneumatics/compressed air.. Cheaper and better option but involves a little more effort is a 1/4" male threaded tee. Drill and tap the male threaded outlet with a 1/8 npt thread, which is very easy as its plastic. Bonus with this option is you can add a 1/4" half nut to the threaded outlet and mount it directly into the chamber floor,lid or wall.